2) wedge-type stamping die
斜楔式冲模
3) bending die with under double wedges
双下斜楔弯曲模
4) wedge
[英][wedʒ] [美][wɛdʒ]
斜楔
1.
The Development of Full Automatic Angular Injection Mold With Driving Wedge;
全自动角式斜楔注射成型机的研制
2.
A pint-size manual fixture based on wedge-lever mechanism;
基于斜楔与杠杆机构的小型手动夹具
5) cam driver
斜楔
1.
Application of single or double cam drivers in bending dies;
单双斜楔在弯曲模中的应用
2.
Over the technology analysis to frame, a feasible bending technology is set up, the bending die structure with cam driver and slide block is introduced, and the critical points during design are introduced as well.
通过对机壳的工艺分析,制定出一种合理的弯曲工艺,介绍了一种带斜楔、滑块的弯曲模具结构,并对设计过程中的要点进行了介绍。
3.
The cutting and bending operations of the die are accomplished in turn with2matrixes driven by2cam drivers.
模具通过2套斜楔驱动2套凹模依次完成钢丝的切断及弯曲成形,提高了工件精度和生产效率,并介绍了模具的工作过程、特点和主要零部件设计。
6) oblique wedge
斜楔
1.
In terms of defects of the traditional oblique wedge die with several side holes that had position degree at the same product,method of integration with rotating wheel and slant was adopted.
针对传统的斜楔模在同一制件上冲制有位置度要求的几个侧孔时的缺点,采用转动盘与斜面相结合的方式,在同一副模具上同时冲出有位置度要求的4个孔。
补充资料：斜楔式侧孔冲模
工件套在件6上用件9上的台阶定位，而件9用件18防转并且起到圆周方向定位的作用，当上模下行时，件5先将工件压牢，上模继续下行时，由斜楔4推动件11和装在件11上的件8完成冲孔工作。当上模上升时件11在件4的作用下退回，按下件16，工件由与件16相连的件9顶出．
工件图
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条