1) polyether-urethane
聚醚氨酯
1.
Evaluation of small-angle X-ray scattering of polyether-urethane;
聚醚氨酯的SAXS研究
2.
A set of polyether-urethane block copolymers were prepared that poly(tetramethylene oxide)PTMEG was regarded as soft segment and 4,4'-methylenebis(phenyl isocyanate)(MDI) was regarded as hard segment in this article.
以聚四氢呋喃二醇 (PTMEG)为软段 ,以 4 ,4’ 二苯基甲烷二异氰酸酯 (MDI)和间苯二胺为硬段 ,合成了一系列聚醚氨酯嵌段共聚物。
3.
Silicon-containing foamed polyether-urethane was prepared by toluenediisocyanate, polyols, foamer dichloromethane and chain extender dihydroxyl tetracoordinate silicon.
以SiO2 为原料 ,通过非碳热法合成出双羟基四配位硅化合物 ;然后以此为扩链剂 ,以二氯甲烷为发泡剂 ,与甲苯二异氰酸酯、聚醚多元醇反应制成含硅发泡聚醚氨酯。
2) polyether urethane
聚醚氨酯
1.
The investigation on polyether urethane and epoxydiacrylates resins simultaneous interpenetrating polymer networks (Ⅰ);
聚醚氨酯环氧树脂同时互穿网络的研究(Ⅰ)
2.
The investigation on polyether urethane and epoxydiacrylates resins simultaneous interpenetrating networks(Ⅱ);
聚醚氨酯环氧树脂同时互穿网络的研究 (Ⅱ )
3.
The preparations of interpenetrating polymer networks (IPNs) based on polyether urethane and epoxydiacrylates resin by simultaneous polymerization technique was investigated.
通过改变聚醚氨酯和环氧丙烯酸酯树脂组分比 ,合成了不同组成的同时互穿网络聚合物 (SINs) ,采用红外光谱 ,扫描电镜和动态热力学分析等测试方法 ,研究了 SINs材料的组分间分子混合和形态结构 ,探讨了材料的组分与力学及热学性能的关系。
3) poly(Ether Urethane)
聚醚氨酯
1.
Synthesis and its damping behavior studies of poly(Ether Urethane) /poly(Methyl Methacrylate) IPNs;
聚醚氨酯/聚甲基丙烯酸甲酯IPN阻尼性能研究
2.
Surface Modification of Poly(ether urethane) Membrane with RGD and Its Cytocompatibility of Human Endothelial Cell;
RGD改性聚醚氨酯及其内皮细胞相容性的研究
5) polyurethane
[英][,pɔli'jʊərəθeɪn] [美]['pɑlɪ'jurə'θen]
聚醚氨酯
1.
In this paper, the interpenetrating polymer network (IPN) based on UV\|curing polyurethane (PU) and epoxy (EP) was studied.
本文以光固化型的聚醚氨酯 (PU)与环氧树脂 (EP)为体系 ,由不同的组成比制备了一系列 PU/EP的 IPN材料 ,经力学性能测试 ,均显正协同效应 ,且协同效应的大小与聚合物网络的互穿程度有关 。
2.
This paper studied the interpenetrating polymer networks based on UV curing polyurethane(PU) and epoxy(EP) with different preparating methods——simultaneous and sequential.
分别采用同步互穿和顺序互穿的方法制备了光固化型的聚醚氨酯（ＰＵ）与环氧树脂（ＥＰ）的互穿网络聚合物（ＩＰＮ）。
6) polyurethane-polyether
聚氨酯-聚醚
1.
The preparation approach of polyurethane-polyether-acrylic resin hydrophilic coating used for aluminum foil was described.
介绍了一种聚氨酯-聚醚-丙烯酸酯型亲水铝箔涂料的制备方法,研究了引发剂的选择和用量对转化率的影响,考察了内交联剂以及聚氨酯-聚醚树脂与丙烯酸树脂的配比对涂料性能的影响。
补充资料：聚氯醚,氯化聚醚
CAS：25323-58-4
分子式：(C5H8Cl2O)x
中文名称：聚3,3-双(氯甲基)丁氧环；氯化聚醚；聚氯醚,氯化聚醚
英文名称：Poly 3,3-bis(chloromethyl)oxetane；Chlorinated polyether；3,3-bis(chloromethyl)-oxetan homopolymer
分子式：(C5H8Cl2O)x
中文名称：聚3,3-双(氯甲基)丁氧环；氯化聚醚；聚氯醚,氯化聚醚
英文名称：Poly 3,3-bis(chloromethyl)oxetane；Chlorinated polyether；3,3-bis(chloromethyl)-oxetan homopolymer
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条