1) interfacial pressure
界面压
1.
It has been shown that there exists a good correlation between interfacial pressure(π),interfacial viscosity(IFV),interfacial primary yield value(IFPYV)of the interfacial film between the water/oil phases and the stability of the emulsions(W/O volume ratio 30/70).
对以大庆和吉林原油界面活性组分为乳化剂的模型乳状液的稳定性与油水界面压、界面膜的界面粘度、界面屈服值的关系进行了研究。
2) interface pressure
界面压力
1.
Objective:To predict the interface pressure between residual limb and prosthetic socket for below-knee (BK) amputees during walking.
目的:为计算小腿截肢患者行走过程中残肢和接受腔之间的界面压力。
2.
The results show that interface pressures ar.
接受腔/残肢界面压力分布特征是假肢优化设计的基础,传统的有限元模型只限于静态分析,不符合实际情况。
3.
Manganin gauges were used to record the interface pressure p exp and p Al between the LY12Al base plate and the explosive sample as well as between the LY12Al plate and LY12Al sample.
利用压力对比法 ,采用锰铜计测量待测炸药样品和LY12铝标准样品在LY12铝飞片同时撞击下的界面压力 ,运用冲击波关系式和正交回归直线拟合分析 ,确定了JB90 14钝感炸药冲击绝热线关系式。
3) interfacial pressure
界面压力
1.
A few problems,during making the cross-linked cable joints,caused by interfacial pressure,withdrawing of cable main insulation layers,humidity and so on,were introduced,some problems noticeable during manufacturing them were analyzed,and the countermeasures were presented in the paper.
通过对110 kV电缆头制作过程中普遍存在的因界面压力、电缆主绝缘回缩、受潮和施工环境等问题的介绍,分析了各环节应注意的问题,提出相应对策。
4) interfacial indentation
界面压入
1.
This interfacial indentation method is suitable for use in those coatings with high bonding strength.
采用具有新颖性的涂层压入仪，在涂层与基体之间的界面压入，可测得压入过程中载荷与压入深度的关系曲线和界面开裂的临界载荷Ｐｗ，此值可反映涂层结合强度。
5) interface compressive stresses
界面压应力
1.
The experiment results show that the interface compressive stresses can decrease the rate of the grains growth, control the transformation of tetragonal during sintering, raise the amount of the transformable tetragonal, strengthen.
研究结果表明,ZrO2层状陶瓷由于界面压应力的作用,抑制了烧结过程中晶粒的生长速度及冷却后四方相向单斜相的转变,提高了可相变四方相的含量,提高了断裂相变量,改善了材料的力学性能,但却没有改变四方相和单斜相之间的晶体学位向关系,在层状ZrO2陶瓷中,(100)m//(010)t的晶体学位向关系仍然存在。
6) Disjoining Pressure of Interfaces
界面分离压
补充资料：冲击波超压与动压