1) Middel Roll Movement
中间辊抽动
2) middle-roll drive
中间辊传动
1.
This paper mainly describes composition of six-high finishing rolling mill in the rolling thin-copper strip,the two different main-drive ways of work-roll drive and middle-roll drive,analyzing-comparing the two main-drive ways.
本文主要描述了在薄铜带轧制中六辊精轧机的组成,工作辊传动和中间辊传动两种不同的主传动方式,并对两种主传动方式进行了对比分析。
4) Intermediate Roller
中间辊，腰辊
5) intermediate table
中间辊道
1.
Simulation and analysis of intermediate table with insulation cover;
热连轧中间辊道加保温罩工艺分析
2.
Simulating and Analyzing of Intermediate Table Insulation Technology in Hot Continuous Rolling;
热连轧中间辊道保温工艺模拟分析
6) intermediate roll
中间辊
1.
Study on the breakage of intermediate roll in SG18-H Mill;
SG18辊冷轧机中间辊断辊原因研究
2.
End contour of intermediate rolls for a UCMW cold tandem mill
UCMW冷连轧机组各架中间辊端部辊形
3.
Rolls' deformation and roll force distribution between rolls on a six-high mill are calculated by influence function method to study the influence of single-taper crowned intermediate rolls on the roll force distribution between rolls and transverse distribution of strip thickness.
用影响函数法计算了六辊轧机的辊系变形和辊间压力分布,研究了单锥度中间辊对辊间压力分布和轧件横向厚度分布的影响·结果表明采用单锥度中间辊可改善辊间压力分布状态,明显降低辊间压力峰值,但轧件横向厚差稍有增加,最大值出现在轧件边部·计算了不同锥度时的辊间压力分布与轧件横向厚度分布,通过比较辊间压力峰值与轧件边部厚度,确定了最佳锥度范围为1/100～1/150,使HC轧机的辊间单位压力峰值降低15%～20%,轧件横向厚差仅在边部增加几微米,符合板形要求
补充资料：抽动
1.肌肉一缩一伸地动。多由于悲伤﹑气愤或疾病。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条