1) sawing area
锯切面积
1.
The kinematic point speed compositive theory isadopted to work out a single diamond grit's sawing area and sawing thickness .
引进运动学中的点的速度合成定理求解单颗金刚石磨粒锯切面积和锯切厚度 ,通过详细的理论推导推出了单颗金刚石磨粒锯切速度方程、锯切运动方程和锯切面积和锯切厚度的计算公式。
2) square-cut;squaresawn
四面锯切的
3) curved band sawing
曲面带锯切割
4) peeling area
旋切面积
5) cutting area
切削面积
1.
The calculating formulas of cutting area of single diamond grain when the diamond circular saw blade rotates along clockwise or counterclockwise with a constant rotational velocity as well as feeding with a constant speed are deduced, and the relationship between the cutting area of diamond grain and sawing parameters is analyzed.
推导了金刚石圆锯片以等角速度作顺时针或逆时针旋转、同时作匀速进给运动时单颗金刚石磨粒切削面积的计算公式 ,并分析了磨粒切削面积与锯切参数的关
2.
The composition of velocity law of the points in kinematics is led into the solving of the cutting area of single diamond grit.
引进运动学中的点速度合成定理 ,求解单颗金刚石磨粒切削面积 。
3.
The factors,which include cutting area,contact arc length,back rake angle,rock strength against drilling and worn height of cutter,on the forces on PDC cutter were analyzed.
模拟钻头上的切削齿的不同的切削断面形状、重叠切削状态及磨损状态,利用PDC切削齿对多种岩样进行了切削试验,研究了切削面积、接触弧长、切削齿后倾角、岩石抗钻强度、切削齿磨损高度等因素对PDC切削齿受力的影响规律。
6) shearing area
剪切面积
1.
Effect of effective shearing area on result of direct shear tests;
有效剪切面积对直剪试验结果的影响分析
2.
The influence of stress state and shearing area on the shearing strength is studied.
剪切面积和应力状态的变化对剪切强度有着重要的影响,分析了剪切面积和剪切位移在剪切过程中的变化,剪切面积对剪切强度的影响随着剪切位移量的增大而呈现非线性增大的趋势。
3.
The results indicated that impact absorbed energy of heat-affected zone in welded joint of X70 pipeline steel were proportional with shearing area on the whole.
结果表明:X70管线钢焊接接头热影响区冲击试样的冲击功与断口剪切面积基本成线性比例关系,冲击功越高,剪切面积越大。
补充资料：积积
1.长久累积。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条