1) pressure runaway
压力失控
1.
The course, causes and improving measures of the pressure runaway accident of the main pipe network of blast furnace gas are described.
介绍了高炉煤气主管网压力失控的事故经过、原因及整改措施;并结合此次事故,谈了控制管网压力、确保管网安全运行及事故状态下人身安全的几点体会。
3) pressure loss
压力损失
1.
Inspecting defects inside impeller of electric submersible pump by fluid pressure loss measurement method;
流体压力损失法检测电潜泵叶轮缺陷的研究
2.
Design and Calculations of the Pressure Loss of Venturi Scrubbers;
文丘里洗涤器压力损失的设计计算
3.
Computerization of pressure loss and equalization in multibrached suction pipeline;
多分支吸风管路压力损失及平衡的计算机处理
4) pressure drop
压力损失
1.
Theoretical approach to pressure drop across cyclone separators;
旋风分离器内压力损失的计算
2.
Experiment and analysis of pressure drop characteristics of flexible duct in air conditioning systems;
空调系统柔性风管压力损失特性实验与分析
3.
Effect of factors on pressure drop in the inertia separation chamber of stripper combine harvester with air suction;
气吸式割前摘脱联合收割机惯性分离室压力损失的影响因素
5) leakage pressure
漏失压力
1.
Statistic analysis of leakage pressure of Ordovician carbonate formation in middle Tarim Basin;
塔中奥陶系碳酸盐岩地层漏失压力统计分析
2.
Drilling fluid leakage is affected by many factors during drilling,which makes it more difficult to determine the value of leakage pressure.
钻井液发生漏失是多因素共同作用下的复杂问题,如何采用合适的计算模型来确定漏失压力的值一直以来都是一个难题。
6) pressure losing
压力损失
1.
Taking the object of transporting carbon black,analyzed the transportation pressure losing of level pipe、vertical pipe and bend pipe of the pneumatic transportation pipe line,gained the pres-sure losing formula of the three sorts of pipe line.
对以炭黑为输送对象的气力输送管道中水平管、垂直管和弯管的输送压力损失分别进行了分析,得到了炭黑在这3种输送管道中的压力损失计算公式。
2.
The result showed the pressure losing with two times draught was slightly lower than that with no two times draught's while empty running.
对吸粮机装置中的单筒型吸嘴进行了实验研究,得出吸粮机空载运行时,有二次进风口的单筒型吸嘴压力损失略低于无二次进风口的单筒型吸嘴压力损失;重载运行时在同一风速下,有二次进风口的单筒型吸嘴输送产量高于无二次进风口的单筒型吸嘴的产量。
3.
According to pressure losing coefficient of hydraulic system parts tested by experiment, the advancing velocity of powered support was calculated under a certain condition.
通过实验室实验来确定支架液压系统各元件的压力损失系数,计算出在一定条件下的液压支架移架速度,计算结果反映了支架移架速度的实际情况,该方法现已应用于支架的液压系统设计并取得良好效果,实现快速移架系统的定量化设计。
补充资料：锅炉、压力容器、压力管道及特种设备定期检验
锅炉、压力容器、压力管道及特种设备定期检验
periodic inspection of boilers, pressure vessels, pressure piping and special equipment
guolu YOli侧飞扣1 YOli gLJal对印ji tez陌叩劝以拍1 dingqi】，on四n锅炉、压力容器、压力管道及特种设备定期检验(peri诫c inspectionof城le。，p~切reves-Sels，p~二piPing ands衅过闪uiplr屺nt)为保证设备的安全使用，规定设备必须按一定周期进行法定的、强制性的检验。定期检验由政府设立的检验所、使用单位或行业检验站进行。检验单位及检验人员必须具有与所检设备相适应的资格。设备使用单位应该建立定期检验制度，做好检验计划，按时向检验单位提出申请。检验单位应该保证及时进行检验，检验按有关检验规则进行。检验时，设备使用单位应做好配合工作，提供必要的运行资料。检验完毕，检验单位要出具检验报告，对设备能否使用，要作出明确结论。如设备有缺陷，要提出是否修理、监护使用和报废的处理意见。锅炉压力容器安全监察机构根据检验机构的报告，发使用许可证书。有缺陷的，责令使用单位修理，修理后检验仍不符合安全要求的，则通知报废。使用单位逾期不进行定期检验，锅炉压力容器安全监察机构有权停止其设备运行。(陈亦惠)
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条