1) collect pan
集水盒
2) collector box
集气盒
3) water receiver
接水盒
1.
The molding process of refrigerator water receiver, structure and work process of injection mold are introduced in detail.
详细介绍了冰箱接水盒注塑件的成型工艺及注射模的结构及工作过程。
2.
Over the forming process analysis to plastic parts of water receiver, a feasible mold design project is provided, and a kind of demoulding mechanism of dual-slanting sliders is designed, which solves the technical problems of demoulding difficulty in lifting ear of plastic parts.
通过对接水盒塑件进行成型工艺分析,提出了合理的模具设计方案,设计了一种双斜滑块脱模机构,解决了塑件挂耳部分脱模困难的技术难题。
4) Perfume cartons
香水盒
6) mercury boxes
水银盒
补充资料:地下水集水构筑物
地下水集水构筑物
groundwater collecting structure
d*x旧shui Jishu一gouzhuwu地T水集水构筑物(groundwater eolleetingstruct盯e)为地下水开采构筑的从含水层中采取地下水的设施。地下水集水构筑物分垂直和水平两类。垂直集水构筑物有管井、大口井等一水平集水构筑物有渗渠。也有二者结合使用的集水构筑物,如辐射井。 管井采用较多的地下水垂直集水构筑物。用钻机钻入含水层下套管和过滤器(见管井施工)成井。它适用于埋藏较深、厚度较大的含水层。井管材料一般采用钢管、铸铁管、混凝土管或塑料管等。井的直径和探度根据水文地质条件和井的出水量等因素确定。通常井的直径在。.sm以内,井的深度在几十米至几百米不等。井管由井壁管、过滤器和沉淀管组成。井壁管下泵部位的内径至少比抽水泵吸水设备的外径大0.05m。过滤器外径按允许入管流速复核,其计算公式为: 。、Q D派-一生二二 一一冗乙nVg式中D为过滤器外径,m;Q为设计出水量,m“/s;L为过滤器工作部分长度,m;n为过滤器表面有效孔隙率;V:为允许入管流速,m/s。过滤器类型可根据含水层的性质选用(见表)。 填砾过滤器的填砾规格可按下列规定确定:(l)砂类含水层,DS。=(6一8)ds。;(2)砾类土含水层,当dZ。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条