1) Circular Gating System
端面环形浇注系统
2) ring-shaped gating system
环形浇注系统
3) Lying tube-annular-gap-typed casting system
卧筒环形缝隙式浇注系统
4) pouring system
浇注系统
1.
Study of the calculating formulas in the minimum section of the gray casting iron pouring system
灰铸铁件浇注系统最小截面积计算公式研究
2.
The injection molding flow of six different pouring system for air-condition panel was analyzed respectively by using Molding Plastics Advisers (MPA)software.
利用模流分析软件Moldflow Plastics Advisers(MPA)对空调机面板注塑模6种构型不同的浇注系统分别进行注射成型流动分析。
3.
The structural characteristics of the aluminum alloy tap part were analyzed, and the design of pouring system and die-casting die structure were introduced.
分析了铝合金水龙头零件的结构工艺性特点,介绍了压铸模的浇注系统及模具结构设计。
5) gating system
浇注系统
1.
Simulation and optimization of gating system of die-casting die for magnesium alloy AM60B part;
AM60B镁合金压铸模浇注系统的模拟与优化
2.
Principle of Designing Gating System for Die Cast Aluminum Alloy Mould;
设计铝合金压铸模具浇注系统类型的原则
3.
Optimization of Gating System for Gear Box of the Car Based on CAE System;
基于CAE分析的汽车齿轮室浇注系统的优化
6) runner system
浇注系统
1.
Design of runner system of injection mould for cellphone glass block;
手机镜片注射模浇注系统设计
2.
Manmade balanced design and numerical simulation for unbalanced runner system;
非平衡浇注系统的人工平衡设计与数值仿真
3.
Optimization of front bumper runner system and its implementation
汽车前保险杠浇注系统优化及实施
补充资料：高炉环形出铁场排烟系统(首都钢铁公司)
高炉环形出铁场排烟系统(首都钢铁公司)
口口尸叮一-一-，一、…澎
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条