1) weak boundary
薄弱界面
1.
The results showed that the yield strength of composite depended on the shear strength at the weak boundary,which was determined by the boundary adhesion and the length,diameter and content of short fibre.
结果发现 ,屈服强度由薄弱界面的剪切强度决定 ,而界面的剪切强度则取决于界面粘合、短纤维长度、直径以及含量等因素 ;拉伸过程中复合材料的界面按照剪切强度由小到大的顺序分段依次被破坏直至断裂 ;短纤维含量较低时 ,其拉伸强度主要由短纤维拔出后的基体承担 ,同时受应力集中影响很大 ,短纤维含量较高时断裂强度则更接近于屈服强度。
2) weak interface
薄弱面
1.
Determination of weak interface distribution range of concrete gravity dam based on reliability analysis;
混凝土重力坝薄弱面分布范围的确定方法
3) weak sections
薄弱截面
1.
In view of the two weak sections consist in the kind of new structure,according to the experiments,measures for shear and interface slip resistance through analysis of the specific location and forming causation concretely of the two weak sections are proposed,obtained good effects.
针对这种新型U型钢-混凝土组合梁的两个受力薄弱截面,并根据试验,分析其具体位置和形成原因,对薄弱截面采取抗剪、抗滑移措施,效果良好。
4) weak interface
弱界面
1.
Research progress in machanible ceramics with weak interfaces in microstructure and materials design;
可加工陶瓷的弱界面结构特征及其研究进展
2.
The failure process and mechanism of a brittle composite matrix,reinforced with long fibers with weak interface,is studied.
研究了弱界面长纤维增强脆性基复合材料在单轴拉伸荷载下的力学性能及其破裂机理和破坏过程。
3.
The special stepped and multi-layered fracture of CePO_4, toge-(ther) with the network structure of intercalated distributional strong-weak interface forming with the addition of CePO_4 which can yield and capture micro-defect, dissipate energy of primary c.
针对工程陶瓷材料本征脆性问题,作者从应力 应变曲线、压痕及压痕尖端的裂纹扩展等方面探讨了可加工Ce ZrO2/CePO4材料的"塑性化",并从显微结构入手,研究了使这种材料产生"塑性化"的机理,即除CePO4本身具有一定的台阶和层片状断裂外,主要由于CePO4的引入出现了强弱界面共同存在的网络结构,弱界面可以产生和捕获微观缺陷,耗散主裂纹扩展能量,导致局部的剪切变形,从而赋予陶瓷"塑性"。
6) soft interface layer
弱界面层
补充资料：薄弱
薄弱
通常是指机体某组织器官的结构或功能不够强大，较纤弱无力，因而易遭致病因子侵袭而患病。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条