1) microwave pulse
微波脉冲
1.
Numerical study on coupling of microwave pulses into different shaped cavities through slots
微波脉冲与不同形状带矩形孔缝腔体耦合的数值模拟(英文)
2.
The finite-difference time-domain method(FDTD) was adopted to investigate linear coupling processes of microwave pulse into the nested rectangular cavities(system 1) and the nested cylindrical cavities(system 2) with same narrow rectangular slots.
为了解带缝腔体内耦合场分布特性,利用时域有限差分方法对微波脉冲与带缝嵌套矩形腔体系统(系统1)和带缝嵌套圆柱形腔体系统(系统2)的耦合过程进行了数值计算。
3.
The sharp reduction of the inductance of the solenoid, caused by dynamite explosion, stimulates a strong oscillatory electric current in such devices, results in a sufficient strong microwave pulse in a quite short time.
通过炸药爆炸使电感迅速减小,以此在螺线管中激发出强的振荡电流并在短时间内产生功率足够强的微波脉冲。
2) pulse microwave
脉冲微波
1.
Objective To observe the effect of pulse microwave combined with antibiotics on chronic prostatitis.
目的观察脉冲微波结合抗菌素治疗慢性前列腺炎的疗效。
2.
Objective: To observe the clinical efficacy of pulse microwave combined with Chinaroot greenbrier rhizome in the treatment of chronic non-bacterial prostatitis(NBP).
目的:观察脉冲微波及中药治疗慢性非细菌性前列腺炎的临床效果。
3.
With the rapid development of science and technology, especially in high power microwave technology, high power pulse microwave sources are widely used.
随着科学技术的发展,尤其是大功率微波技术的发展,大功率脉冲微波信号源应用越来越广泛,这样对功率和频率测量设备的要求也越来越高。
3) pulsed microwave
脉冲微波
1.
Objective:To establish methods of measurement and evaluation of the characteristics of pulsed microwave ra-diation field,and provide basic data for researches on dosimetry and biological effects.
目的:建立脉冲微波辐射场特性参数的检测与评价方法,为剂量学和生物效应研究提供基础数据。
2.
Emulsion polymerization of styrene and methyl methacrylate were investigatedthrough pulsed microwave irradiation under higher pulse power.
利用高功率脉冲微波辐射进行了苯乙烯和甲基丙烯酸甲酯的乳液聚合，考察了引发剂浓度、聚合时间、温度、脉冲功率、占空比、辐射能量和脉冲宽度对聚合转化率和分子量的影响。
4) high power pulsed microwave
高功率脉冲微波
1.
In this process, microwave heating and microwave induced plasma are combined in the same microwave applicator, and the high power pulsed microwave is used to heat active component supported by powder or monolithic support and induce plasma on the support surface simultaneously under atmospheric pressure.
在高功率脉冲微波辐照下，甲烷可在常压条件下，在活性炭、碳化硅和活性炭／碳化硅等三种催化剂上直接转化为Ｃ２烃。
6) broad band microwave pulse
宽带微波脉冲
补充资料：GQDM系列单级脉冲干燥机
 单级脉冲气流干燥机： 适用于各类含表面水份的粉粒状、松散结晶物料干燥脱水，采用先进的脉冲强化换热结构，通过改变物料与热介质之间的相对速度，有效地强化热质交换过程。 特点： 1．干燥时间短、脱水速度快、一般在0.5-3秒。热效率高、且产品不产生过热现象。自动化程度高、干燥产品质量好。 2．干燥强度大、脱水能力可从25 kgH2O/h至2000 kgH2O/h。 3．设备简单、占地面积小、投资省，GQW型为专用低高度紧凑型。 4．应用范围广，可适用于各种粉粒状、膏糊、滤饼类物料。 5．可根据用户情况及物料耐热温度选择蒸汽、电、热风炉、烟气炉、锅炉烟气余热等作为热源。热介质的温度可以从120℃至780℃之间选择。 选型表：
|
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条