1) cavitation-induced martensite
空蚀诱发马氏体
2) deformation-induced martensite
形变诱发马氏体
1.
Effect of quenching temperature on deformation-induced martensite of Ti-3Al-4.
5V-5Mo钛合金形变诱发马氏体的影响。
2.
The paper deals with the super-elasticity and compressed deformation-induced martensite at room temperature , indicates the changing trends of the martensite, contrasts the microstructure and properties of two sputtering films ( magnetron sputtering and ion beam sputtering ), confirms the preparation method and the anneal technics, furthermore, observes the martensite at low temperature.
7at%Ni合金在室温时的超弹性及压缩变形形变诱发马氏体,揭示了室温压缩变形形变诱发马氏体演变过程,对比了磁控溅射和离子束溅射方法制备薄膜的显微组织性能,明确了薄膜的制备及品化处理工艺,并观察了TiNi薄膜在温度作用下的马氏体组织。
3) stress-induced martensite
应力诱发马氏体
1.
The reverse transformation temperature interval of the stress-induced martensite is much sm.
用在(Ms+30℃)温度下的拉伸实验和差示扫描量热仪(DSC)较系统地研究了 Ti44Ni47Nb9 宽滞后形状记忆合金应力诱发马氏体的相变行为。
2.
The results showed that cold rolling process can induce texture of stress-induced martensite and two-way shape memory effect in specific direction.
5Mn合金的双程形状记忆效应的各向异性及其产生机制进行了研究·结果表明,冷轧可造成马氏体织构,且马氏体织构按最大程度缓和外加应力的方式产生,并在特定方向上产生形状记忆效应·通过对压下量的控制,可以在一定范围内任意获得正、负的自发形状变化和热膨胀性·随着加工量的增加,马氏体相变温度区间大幅度扩大·随着温度变化,具有择优取向的应力诱发马氏体晶核的生长和消失是导致可逆的自发形状变化各向异性的根本原因
3.
The reverse transformation temperature interval of the stress-induced martensite was found to be much smaller than that of the thermally induced m.
采用差示扫描量热仪(DSC)系统研究了在(Ms+30℃)温度下拉伸形变对Ti44Ni47Nb9形状记忆合金应力诱发马氏体(SIM)相变行为的影响。
4) thermal induced martensite
热诱发马氏体
1.
Effect of the amount of thermal induced martensite,M_s temperature,vacancy concentration,stacking fault energy etc on the SME was discussed systematically.
通过对合金光学显微组织、透射电镜组织的观察并结合奥氏体晶粒尺寸、形状回复率、层错几率等性能的测量,系统地讨论了不同淬火温度下,热诱发马氏体数量、Ms点、空位浓度、层错能等对形状记忆性能的综合影响,进一步探讨淬火温度对形状记忆性能影响的微观机制。
2.
The reverse transformation of thermal induced martensite, general stess induced martensite, the stress induced martensite after thermomechanical training in Fe Mn Si based shape memory alloys were studied by an electrostatic audio frequency internal friction instrument.
利用音频内耗仪测试了Ｆｅ－Ｍｎ－Ｓｉ基形状记忆合金热诱发马氏体、一般应力诱发马氏体和热－机械训练后的应力诱发马氏体的逆相变过程。
5) induced-transformed martensite
诱发转变马氏体
6) stress induced martensite
应力诱发马氏体
1.
The results show that the reverse transformation temperature of stress induced martensite is higher than that of thermal induced martensite and with the increase of deformation the reverse transformation temperature increases.
0 4 9N(质量分数 ,% )合金预应变对应力诱发马氏体相变量及其逆相变温度的影响 。
2.
The volume fraction of stress induced martensite (SIM) in Fe Mn Si Cr N shape memory alloy was determined by X ray diffraction method.
通过 X射线衍射峰位置和强度的计算 ,可以测定 Fe- Mn- Si- Cr- N形状记忆合金中应力诱发马氏体 (ε相 )体积分数 。
3.
The reverse transformation of thermal induced martensite, general stess induced martensite, the stress induced martensite after thermomechanical training in Fe Mn Si based shape memory alloys were studied by an electrostatic audio frequency internal friction instrument.
利用音频内耗仪测试了Ｆｅ－Ｍｎ－Ｓｉ基形状记忆合金热诱发马氏体、一般应力诱发马氏体和热－机械训练后的应力诱发马氏体的逆相变过程。
补充资料：马群空
1.比喻人才得到充分的选拔和任用。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条