2) high-temperature ablative material
高温烧蚀材料
3) ablation temperature
烧蚀温度
4) high-temperature corrosion
高温腐蚀
1.
Investigations on outer thermal spraying and inner shot blasting on boiler tube to promote high-temperature corrosion resistance;
采用外壁喷涂与内壁喷丸方法提高锅炉高温受热面管抗高温腐蚀性能的试验
2.
The large amount of vanadium in Orimulsion may cause unexpected problems in the prevention of high-temperature corrosion of furnace.
奥里油中含钒量较多,是锅炉预防高温腐蚀设计中的大难题。
3.
The mechanism of high-temperature corrosion on water-wall of coal-fired boilers in thermal power plants has been briefly presented, and preventive countermeasures being put forward directing against different causes of high-temperature corrosion, the prevention technology of spraying corrosion-resistant metallic coatings onto surface of the water-wall being emphatically narrated.
简要介绍了火电厂燃煤锅炉水冷壁高温腐蚀机理,并针对不同的高温腐蚀原因提出了防护对策。
5) high temperature erosion
高温冲蚀
1.
The results showed that coating had typical layer shape,relatively high bonding strength and hardness,excellent high temperature erosion resistance because of the improvement on the erosion properties with the increase of temperature and angle.
结果表明,Fe-Al/Cr3C2复合涂层具有典型的层状结构、较高的结合强度和硬度;涂层的耐高温冲蚀性能良好,温度升高、角度增大,冲蚀性能提高;由于Cr2O3的存在以及涂层结合能的提高,Fe-Al/Cr3C2涂层的高温抗腐蚀性能较高;其常温和高温耐磨损性能也较高;应用研究表明,该涂层适合用于电站锅炉“四管”的防护。
2.
Results show that in comparison with substrate,the coatings possess excellent high temperature erosion resistances,erosion resistance improved with the increasing of temperature and impact angle;they also possess good high temperature corrosion properties,corrosion rate raised a little with the rising of temperature;the coatings have excellent room temperature .
用高速电弧喷涂技术制备了FeAlCr/Ni包Cr3C2 涂层 ,并对涂层的耐高温冲蚀性能、高温腐蚀性能和高温磨损性能进行了研究。
3.
The high temperature erosion of utility boiler tubes (water wall,superheater,reheater and economizer tubes)by fly ash is recognized as being one main cause of utility boiler tube failures.
水冷壁、过热器、再热器及省煤器管道的飞灰高温冲蚀磨损是电站锅炉管道失效的主要原因之一。
6) high temperature corrosion
高温腐蚀
1.
Study on high temperature corrosion resistance of FeCrAl and NiCr alloy coating;
FeCrAl和高镍铬合金涂层的抗高温腐蚀性能研究
2.
High Temperature Corrosion of Superheater Tube Materials in Pulverized Coal-Fired Environment;
粉煤燃烧环境中过热器管材的高温腐蚀
3.
Cause analysis of high temperature corrosion and precautionary measures for a 300MW boiler furnace;
燃煤锅炉炉膛高温腐蚀原因及对策
补充资料：铂改性铝涂层IN738LC耐蚀高温合金热腐蚀产物
铂改性铝涂层IN738LC耐蚀高温合金热腐蚀产物
IIL_一_一了
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条