1) insertion loss
插损
1.
The insertion loss of the switch was less than 1.
5GHz能够达到45dB,插损<1。
2.
The insertion loss is less than 0.
采用此设计的双联波导开关具有良好的性能,主要性能为:插损小(<0。
3.
Because of the new structure, it becomes smaller volume, lower insertion loss, higher directionality and broader bandwidth, and it is easier to manufacture and test.
该方案可使电桥方向性更好、制作工艺更加简便,其带宽可达到9GHz～11GHz,可以承受较大的功率容量,体积小,新式结构使其实现了低插损、高方向性和宽频带,并且易生产、易调试。
2) insert loss
插损
1.
The filter shows a satisfactory test result with 1 12 GHz central frequency,5% passband,and 11 dB insert loss.
12 GHz,带宽达 10 % ,插损为 11d
3) insertion loss
插入损耗
1.
Research on measures to increase insertion loss of power line filter;
提高电源滤波器插入损耗措施的研究
2.
The design of low insertion loss arrayed waveguide grating;
AWG插入损耗性能的分析和改善
3.
A method to analyze insertion loss of electroabsorption-modulator using photocurrent and power transmission vs.wavelength
一种利用光电流和光透过曲线测量电吸收调制器插入损耗因素的方法
4) Insert loss
插入损失
1.
A Study on the Relationship between Vibration Level Difference and Insert Loss;
振级落差和插入损失对应关系的研究
2.
At present the equation of insert loss hasn t indicated the effect of absorption,only refers to the effect of sound insulation.
目前对声屏障的插入损失计算所用的公式,没有体现材料吸声对绕射声衰减的作用,只是反映屏障的隔声作用。
3.
It is shown that the insert loss of an improved muffler is increased by 7.
台架试验证明改进后的消声器插入损失增加7。
5) insertion loss
插入损失
1.
Calculation of insertion loss of the muffler with multi insert pipe parallel structure;
多个内插管并联结构消声器的插入损失计算
2.
Analysis of sound insertion loss model of bubble screen and inverse calculation of structure parameters;
气幕的声插入损失模型分析及结构参数逆算
3.
The axial perforated pipe silencer insertion loss with the frequency,the design parameter change graphic model as well as the stream velocity and the temperature to the noise elimination performance influence graphic model was simulated using MATLAB.
基于传递矩阵法,推导基本传递矩阵建立数学模型,运用Matlab数学编程软件编制程序,仿真计算了轴向穿孔管消声器的插入损失随频率、结构参数变化的三维图以及气流速度和温度对消声性能影响的三维图,仿真结果表明:穿孔率、穿孔管壁厚、气流速度和温度对消声器消声性能有着重要影响,这对消声器设计及改进有着重要的指导意义。
6) insert loss
插入损耗
1.
By testing the insert loss of the inductance with ferrite core,the effective magnetic per- meability is obtained.
通过测量磁性磁芯电感器的插入损耗,进而得出材料的有效磁导率。
2.
Analyses insert loss and reflect loss under mismatch impedance conditions and proposes the decision principle of EMI filter.
为了使EM I滤波器的传导EM I信号在其内部得到最大衰减,依据EM I滤波器应具有双向抑制性的基础上,分析了阻抗失配对插入损耗和反射损耗的影响,给出了理想EM I滤波器的确定原则,以及为减小阻抗失配给插入损耗带来的影响,提出了实际设计和选用EM I滤波器时应遵循的最大失配原则。
3.
Reducing the insert loss of collimator is the difficult problem to produce this kind of component.
降低准直器的插入损耗是生产准直器的难点,本文在几何光学和高斯光束传输理论的基础上,利用矩阵光学原理和高斯光束耦合理论对准直器的原理和损耗进行计算和分析,提出一种用自聚焦透镜与球面透镜进行匹配的方法,并通过实验证明该方法能有效降低准直器的插入损耗,在生产过程中将逐渐采用这种方法进行装配,以提高生产效率。
补充资料：插插
1.犹喳喳。低语声。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条