1) SB latex
SB胶乳
1.
Along with the technology of emulsion polymerization improved continuously, people not only boost the qualities of SB latex from polymerization, but also make further consideration to control the molecular structure on polymerization clay always is th.
文章从五个方面介绍全球涂布化学品的现状与发展 ,占造纸原料的 8%为颜料和填料 ,而在占造纸原料 1 %的合成化学品中 ,涂布胶乳占到 5 0 %,其中又以SBR为主体 ,随着乳液聚合工艺水平的不断提高 ,人们已经从单纯的聚合方面来改进SB胶乳的质量 ,开始进一步考虑控制聚合的分子结构。
3) stibium
[英]['stibiəm] [美]['stɪbɪəm]
Sb
1.
After dissolved by nitric acid and hydrochloric acid, several same samples were added into the five element standard solutions increased by concentration degrees,respectively,then the contents of iron,lead,stibium,zinc and nickel were determined successively by fire atomic absorption spectrometry(FAAS).
用HNO3-HCl溶解试样,在几个相同量的试液中,分别加入质量浓度依次递增的5种元素的标准溶液,用火焰原子吸收法连续测定了Fe、Pb、Sb、Zn和Ni的含量,建立了优化的仪器测定条件,并对可能存在的元素进行了干扰试验。
2.
A new environmental friendly cutting brass containing bismuth and stibium instead of lead was produced by casting and extruding.
采用熔铸、挤压的方法生产出以Bi和Sb代铅的环保型易切削黄铜棒材。
4) antimony
[英]['æntɪməni] [美]['æntə'monɪ]
Sb
1.
7Si magnesium alloy modified by antimony,were investigated.
研究了Sb变质Mg-6Al-1Zn-0。
2.
After dissolved by HCl-HNO_3,samples were added into the nine elements' standard solutions increased by concentration degrees respectively,then the contents of nickel,copper,manganese,iron,lead,antimony,zinc,calcium and magnesium were determined by air-acetylene fire atomic absorption spectrometry (FAAS).
用王水溶解试样,在几个相同量的试液中,分别加入浓度依次递增的9种元素的标准溶液,用空气-乙炔火焰原子吸收法连续测定N i、Cu、Mn、Fe、Pb、Sb、Zn、Ca、Mg的含量。
3.
Batch experiments were conducted to investigate the effects of ZVI concentrations,the initial antimony concentrations,initial solution pH,and anions on antimony removal with zero-valent iron .
锑(Sb)是一种新兴的全球性污染物,在我国西南Sb矿区及周边地区Sb污染严重。
5) latex
[英]['leɪteks] [美]['letɛks]
胶乳
1.
Experiment of salt-resisting performance of polyvinyl alcohol latex oil-well cement;
聚乙烯醇胶乳油井水泥抗盐性能实验
2.
Synthesis of large particle polybutyl acrylate latex;
大粒径聚丙烯酸丁酯胶乳的制备
3.
Improvement of latex on mechanical deformation capability of cement sheath under triaxial loading condition;
胶乳对水泥石三轴力学形变能力的作用
6) emulsion
[英][ɪ'mʌlʃn] [美][ɪ'mʌlʃən]
乳胶
1.
The initiator is summarized in grafting copolymerization preparation emulsion with using starch and ethenyl monomer , each kind of initiator mechanism is commented, influence of the initiator selecting to the emulsion performance is elaborated.
总结了淀粉与乙烯基单体接枝共聚制备乳胶常用的引发剂,对各类引发剂的机理作了评述,讨论引发剂的选用对乳胶性能的影响。
2.
The process of manufacturing emulsion products and its capacity indexes have been analyzed in this paper.
本文分析了乳胶制品的生产过程，并对工序能力指数进行了分析，从而推断出产品的质量。
3.
Methods: A random, single blind, positive-control and multi-center clinical trial recruited 230 patients with osteoarthritis, who were randomly applied onto the affected area with either piroxicam patch (n = 116) once every other day or diclofenac emulsion (n = 114) three times per day for 14 days.
方法:研究采用多中心、随机、单盲、阳性药(双氯芬酸乳胶)平行对照。
补充资料：d-gluconic acid, 2,4:2',4'-o-(oxydistibylidyne)bis-, sb,sb'-dioxide, trisodium
CAS: 16037-91-5
分子式: C12H18Na2O17Sb2
"中文名称: 葡萄糖酸锑钠；葡酸锑钠；斯锑黑克
英文名称: d-gluconic acid, 2,4:2',4'-o-(oxydistibylidyne)bis-, sb,sb'-dioxide, trisodium；salt, nonahydrate；antimony sodium gluconate；d-gluconic acid, cyclic ester with antimonic acid (h8sb2o9) (2:1), trisodium sodium stibogluconate；solustibosan；solustin
性质描述: 白色或微显淡黄色无定形粉末。易溶于热水，溶于水，不溶于乙醇或乙醚。无臭。水溶液显右旋性。
生产方法: 葡萄糖酸钙与碳酸钠置换反应生成葡萄糖酸钠，然后用三氯化锑进行锑化反应得到葡萄糖酸三价锑钠盐，最后用双氧水氧化为葡萄糖酸锑钠。
用途: 抗黑热病药。
分子式: C12H18Na2O17Sb2
"中文名称: 葡萄糖酸锑钠；葡酸锑钠；斯锑黑克
英文名称: d-gluconic acid, 2,4:2',4'-o-(oxydistibylidyne)bis-, sb,sb'-dioxide, trisodium；salt, nonahydrate；antimony sodium gluconate；d-gluconic acid, cyclic ester with antimonic acid (h8sb2o9) (2:1), trisodium sodium stibogluconate；solustibosan；solustin
性质描述: 白色或微显淡黄色无定形粉末。易溶于热水，溶于水，不溶于乙醇或乙醚。无臭。水溶液显右旋性。
生产方法: 葡萄糖酸钙与碳酸钠置换反应生成葡萄糖酸钠，然后用三氯化锑进行锑化反应得到葡萄糖酸三价锑钠盐，最后用双氧水氧化为葡萄糖酸锑钠。
用途: 抗黑热病药。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条