1) Collosol Motor
溶胶马达
2) Injecting Motor
射胶马达
3) dammar varnish
达马胶漆(玻璃装饰用)
4) motor
[英]['məʊtə(r)] [美]['motɚ]
马达
1.
Multi-sensor fusion and control system for pump & motor of shearer based on dual-CPU structure;
基于双CPU结构的采煤机泵、马达多传感器融合与控制系统
2.
The Technique in Hydraulic Pump and Motor Test-bed Measure System;
液压泵、马达试验台技术概况
3.
Failure mechanism and measure analysis of motor stator of screw drill;
螺杆钻具马达定子失效机理及措施分析
5) sols
溶胶
1.
Synthesis of MoO3 nanobelts with no template via a simple hydrothermal method from peroxomolybdic acid sols was reported.
以过氧钼酸溶胶为反应前驱体采用简单的水热方法,在没有任何模板剂的条件下合成三氧化钼纳米带,通过XRD,SEM,TEM和IR等测试方法对产物进行结构表征和形貌分析。
2.
Translucent SiO_2 sols are prepared from TEOS using NH_3·H_2O as catalyzer,polyelectrolyte/ SiO_2 composite films are fabricated via electrostatic self-assembly multilayer method,and SiO_2 thin films are formed by heat-treating the polyelectrolyte/SiO_2 composite films to eliminate the polyelectrolyte and other components in compos- ite films.
以氨水为催化剂,通过水解正硅酸乙酯制备了乳白色二氧化硅溶胶,采用静电自组装薄膜技术制备了聚电解质/二氧化硅复合薄膜,并通过热处理制备了二氧化硅薄膜。
3.
The average thickness of the interface layer wrapped about sols usually is determined by fitting the Porod curve that shows a negative deviation from Porod's law.
溶胶界面层厚度通常是用Porod法对高角区负偏离的Porod曲线进行拟合求算 ,但本文研究表明还可通过分别测定Porod负偏离校正前后体系粒子的平均半径之差而获得平均界面厚度 。
6) peptization
[,peptai'zeiʃən]
胶溶
1.
During the process of peptization and hydrothermal crystallization, the aggregation behavior and the resulting morphology of nanocrystalline titania (TiO2) were studied by X-ray diffraction (XRD), scanning electron microscope (SEM), and dynamic light scattering (DLS) techniques.
通过XRD、SEM和动态光散射粒度测定仪(DLS)研究了胶溶及水热晶化过程中纳米TiO2晶粒聚集行为及形貌。
2.
The A1(OH)3 sol and Al(0H)3—Zr(OH)4 sol is prepared by peptization method with A1(NO3)3 , ZrOCl2 and NH3H2O as starting materials, using A1(NO3)3 solution and Zr(OH)4 sol as peptizing agents, and the preparation process, preparation conditions and colloid structure are analyzed.
本文以Al(NO_3)_3,ZrOCl_2和氨水为原料,分别以Al(NO_3)_3溶液和Zr(OH)_4溶胶作为胶溶剂,通过胶溶法制备Al(OH)_3溶胶和Al(OH)_3—Zr(OH)_4溶胶,并对两种溶胶的制备过程,制备条件和胶团结构进行了分析。
补充资料：Usm超声波马达
usm超声波马达定位精准、运动安静平稳，是享有盛誉的镜头马达，由于它具备以上特点，所以一直被应用在佳能单反相机的专业镜头上，应用在小型数码相机上，提供了安静顺畅的变焦动作。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条