1) Immobilized bacterium
固定化菌
1.
The initial study of the biodegradation of LAS by immobilized bacterium shows that the optimal pH and temperature range of LAS biodegradation by immobilized bacterium was bigger than that of LAS degradation by suspended bacterium.
以海藻酸钠为载体将筛选出的杰氏棒杆菌进行固定化包埋,并对固定化菌降解LAS废水进行了实验研究。
2) immobilized bacteria
固定化细菌
1.
The nitrogen removal effect by immobilized bacteria in fluidized bed was studied by means of bacteria screening,carrier preparation,selection of operation process and so on.
从金山湖天然水体中筛选出具有生态安全性的土著氨化、硝化、亚硝化、反硝化细菌,通过细菌筛选、载体制备、运行工艺选择等对固定化细菌流化床脱氮效果进行研究。
2.
The results showed that the carbon sources can be used by the immobilized bacteria as exogenous carbon sources.
固定化细菌能利用水中部分的有机物进行反硝化作
3) immobilized bacteria-algae
菌藻固定化
1.
Experiment results showed that the removal efficiency of nitrogen and phosphorus by immobilized bacteria-algae beads were 100% and 89.
实验结果表明,固定化菌藻对氮磷的去除效果优于固定化细菌和固定化藻类;在污水中添加葡萄糖的条件下,菌藻固定化胶球在44h时对NH+4-N和PO43--P分别达到100%和89。
4) immobilized strain
固定化菌株
1.
Degradation of methyl tert-butyl ether (MTBE) on immobilized strain NERC0401(Klebsiella oxytoca) embedded in calcium alginate was carried out by batch method.
实验结果表明,固定化菌株NERC0401对水体中MTBE的降解效果较游离态菌株NERC0401有所提高,对初始环境pH和MTBE初始质量浓度的适应性得到一定的改善。
5) immobilized algal-bacteria
固定化藻菌
1.
Effect of cell concentration on the removal of nitrogen and phosphorus in synthetic wastewater by the immobilized algal-bacterial system;
固定化藻菌的小球浓度对模拟生活污水脱氮除磷效果的影响
2.
Removal of nitrogen, phosphorus and organic matters by immobilized algal-bacteria under fluidization condition
固定化藻菌流态化去除氮磷及有机物的研究
3.
The experiments carried in the fluidized photobioreactor for treating beverage wastewater by putting in the immobilized algal-bacterial beads, with discussion of the effect of gas velocity,liquid velocity and the density of immobilized algal-bacterial on the removal efficiency.
在自制的流化床光生物反应器中加入固定化藻菌小球来处理饮料废水,主要探讨了反应器中气速、液速以及固定化藻菌小球密度对系统去处效率的影响。
补充资料：固定化固定相开管柱
分子式：
CAS号：
性质：固定化固定相是：(1)固定相分子间进行共价交联；(2)固定相与毛细管内表面进行化学键合。主要固定化方法有原位加热缩合法、原位自由基诱导法等。通常涂渍方法制备的开管柱在升温使用中，不同程度发生固定液流失、液膜破裂等现象，而固定化固定相开管柱柱性能稳定，柱效高。
CAS号：
性质：固定化固定相是：(1)固定相分子间进行共价交联；(2)固定相与毛细管内表面进行化学键合。主要固定化方法有原位加热缩合法、原位自由基诱导法等。通常涂渍方法制备的开管柱在升温使用中，不同程度发生固定液流失、液膜破裂等现象，而固定化固定相开管柱柱性能稳定，柱效高。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条