1) phase precipitation
相析出
1.
We will explain the phenomena by the theory of micro-distortion and phase precipitation.
目前国内外对这种特性的机理研究文章不多,本文用微观畸变与相析出理论解释了这一特性,对该合金经860℃固溶、50%形变、450℃时效不同时间的强化机制进行了研究。
2.
The phase field model for predicting second-phase precipitation was established based on constructing local free energy flmetion and considering the effect of grain boundary on the second- phase precipitation process.
通过构建局域自由能函数,并考虑晶界对析出过程的影响,建立了低体积分数相析出过程的相场模型,模拟了溶质体积分数为2%的体系中第二相在晶界和晶内析出及其演变过程。
2) precipitated phase
析出相
1.
Evolution of precipitated phase during aging treatment in 316L austenitic stainless steel
316L奥氏体不锈钢中时效条件下析出相演变行为的研究
2.
The microstructure and precipitated phase of C194 alloy were investigated by means of transmission electron microscopy(TEM).
用透射电子显微镜对市售的两种编号为A、B的C194铜带的显微组织和析出相进行了观察分析,结果表明两种试样的析出相都是Fe3P,只是A试样的析出相有两种形态,一是直径为50nm～70nm的球形Fe3P,另一种为10nm左右的微小Fe3P粒子。
3) precipitate
[英][pri'sipiteit] [美][prɪ'sɪpɪ,tet]
析出相
1.
Effect of an electromagnetic field on precipitates in the composite interface of Al-Mg/Al-Si;
电磁场对Al-Mg/Al-Si复合界面析出相的影响
2.
EBSD analysis of the precipitate in electrodeposited nanocrystalline Ni after annealling;
电解沉积纳米镍退火析出相的EBSD分析
3.
Precipitates of Cu-0.3Cr-0.15Zr Alloy During Aging;
Cu-0.3Cr-0.15Zr合金时效时的析出相
4) precipitates
[英][pri'sipitit] [美][prɪ'sɪpətɪt]
析出相
1.
Investigation on dissolution of precipitates in Al alloy deformed by equal-channel angular pressing and multi-axial compression;
铝合金等径角挤压和多向压缩变形中析出相的回溶研究
2.
Heat Resistance of Precipitates in Mg-9Gd-4Y-0.6Zr Alloy at Elevated Temperature;
Mg-9Gd-4Y-0.6Zr析出相在高温拉伸中的相变
3.
Influence of the Precipitates on the Corrosion Behaviors of Low Carbon Cast Nickel Molybdenum Alloy;
低碳镍钼合金的析出相及其对合金腐蚀的影响
5) precipitation
[英][prɪ,sɪpɪ'teɪʃn] [美][prɪ'sɪpə'teʃən]
析出相
1.
Effect of aging temperature on precipitation of Super304H steel
时效温度对Super304H钢析出相的影响
2.
Major precipitations in C-22HS alloy are granular(Mo,Cr)6C and dispersed distr.
结果表明:标准热处理状态下C-22HS合金由大小不均匀的等轴晶组成,合金中析出相主要有聚集分布的颗粒相(Mo,Cr)6C和弥散分布的强化相Ni2(Mo,Cr)。
3.
There unevenly distributed second-phase precipitations at the Fe_3A1/18-8(stainless steel) diffusion bonding interface directly.
Fe3A1/18-8扩散焊界面不均匀地分布着第二相析出物,特别是交界面处连续分布的析出相族可能直接诱发裂纹,是引起接头失效的重要因素。
6) Al_(3)Sc precipitates
Al3Sc析出相
补充资料：白细胞析出
白细胞析出
白细胞通过血管壁进入周围组织的过程，又称白细胞渗出。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条