1) Cr18Ni9Ti
1Cr18Ni9Ti
1.
Welding of 1Cr18Ni9Ti Pressure Pipe;
1Cr18Ni9Ti压力管道的焊接
2.
The corrosive mechanism of the steel 1Cr18Ni9Ti was introduced in this article.
主要介绍了1Cr18Ni9Ti的腐蚀机理 ,通过改用纯钛材料 ,取得了良好的经济效益。
3) 1Cr18Ni9Ti pipe
1Cr18Ni9Ti管
4) Cr18Ni9Ti steel
1Cr18Ni9Ti钢
1.
Fatigue behavior of 1Cr18Ni9Ti steel at low temperatures and in vacuum;
低温与真空条件下1Cr18Ni9Ti钢的疲劳行为
5) steel 1Cr18Ni9Ti
1Cr18Ni9Ti钢
1.
This paper discusses heat strength treatment mainly by "polynization strength" treatmenteffecting creep property of steel 1Cr18Ni9Ti and computer optimizaing of "polynization strength"treatment and strength mechanism.
研究的热强化处理主要是以"多边化强化"处理对1Cr18Ni9Ti钢蠕变性能的影响，探讨了"多边化强化"工艺可有效地改善1Cr18Ni9Ti钢的蠕变性能，大大地减小其蠕变变形量和残余变形量，特别是能显著减小蠕变第一阶段的变形量，同时缩短蠕变第一阶段的时间。
6) 1Cr18Ni9Ti steel
1Cr18Ni9Ti钢
1.
Tensile properties and fracture appearance of 1Cr18Ni9Ti steel welded joint at low temperature;
低温下1Cr18Ni9Ti钢焊接接头的拉伸性能和断口形貌研究
2.
Tensile deformation behavior of 1Cr18Ni9Ti steel at low temperatures;
1Cr18Ni9Ti钢的低温拉伸变形行为
3.
Effect of cooling rate on solidification structure in high temperature brittle zone of 1Cr18Ni9Ti steel
冷却速率对1Cr18Ni9Ti钢高温脆性区凝固组织的影响
补充资料：Ti-13V-11Cr-3A1 alloy
分子式：
CAS号：
性质：β钛合金。成分为钒13％，铬11％，铝3％，余量钛。退火后室温机械性能：抗拉强度862MPa，屈服强度827MPa，延伸率10％，弹性模量10.34×104MPa，HRC硬度32～36。采用真空自耗电弧炉熔炼制取。制造紧固件和较大面积的模锻件。
CAS号：
性质：β钛合金。成分为钒13％，铬11％，铝3％，余量钛。退火后室温机械性能：抗拉强度862MPa，屈服强度827MPa，延伸率10％，弹性模量10.34×104MPa，HRC硬度32～36。采用真空自耗电弧炉熔炼制取。制造紧固件和较大面积的模锻件。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条