1) Ti-containing mineral
含钛矿物
1.
An investigation is made of the reaction kinetics of Ti-containing minerals using diasporic bauxite as raw material according to the principle of the equal-reaction efficiency method.
以中国某矿区的一水硬铝石型铝土矿为原料,采用等溶出率方法的原理,进行了含钛矿物反应动力学的研究。
2) titaniferous ore
含钛矿
1.
2 blast furnace at Magang and laboratory make-up slag samples were tested, the reasonable consists of the slag with smelting titaniferous ore was acquired.
通过对马钢第一、第二铁厂高炉现场炉渣及试验室配制渣样的性能测试与矿相分析 ,得出含钛矿炉渣的合理渣系结构 ,并建立了含钛炉渣成分与其性能之间的数学模型。
3) TiO2-containing iron ore
含钛铁矿
1.
The influence of TiO2-containing iron ore’s allocated proportion and basicity on the sinter anti-compressive strength was studied through the mini-sintering experiment.
应用微型烧结法试验,研究了含钛铁矿配比和碱度对烧结矿抗压强度的影响。
4) slag containing titania
含钛矿渣
1.
The removal efficiency of nitrobenzene ultrasonic catalyzed by the slag containing titania prepared had been investigated.
以含钛矿渣为催化剂,在超声波作用下对硝基苯废水进行了催化降解研究。
2.
The removal efficiency of nitrobenzene(NB) catalyzed by slag containing titania under ultrasound(US) was investigated,and the products were also analyzed by high performance liquid chromatography.
以含钛矿渣为催化剂,用超声法对含硝基苯(nitrobenzene,NB)废水进行了降解,用高效液相色谱仪对降解产物进行了分析。
5) materials containing titanium
含钛物料
1.
By using the materials containing titanium in the BF operation are the one of the important techniques prolonged BF campaign.
高炉含钛物料冶炼是提高炉龄的重要技术措施之一,其效果与高炉冶炼强度、耐火材料品质和铁水含钛量等有关。
6) Ti-containing Ta/Nb ore
含钛钽铌矿
补充资料：含钛碳化硅纤维
分子式：
CAS号：
性质：其组成为Si 51.0%，C 27.9%，O 17.7%，Ti 3.1%。纤维直径8.5～1.1μm，密度2.37g/cm3，拉伸强度2.9GPa，模量190GPa。制法是将含钛聚碳硅烷用烷氧基钛改性处理并熔纺，再于200℃以下空气中不熔化和在1000～1500℃的惰性气体中烧成。主要用作抗氧化的复合材料，应用于宇宙飞船和发动机结构材料等。
CAS号：
性质：其组成为Si 51.0%，C 27.9%，O 17.7%，Ti 3.1%。纤维直径8.5～1.1μm，密度2.37g/cm3，拉伸强度2.9GPa，模量190GPa。制法是将含钛聚碳硅烷用烷氧基钛改性处理并熔纺，再于200℃以下空气中不熔化和在1000～1500℃的惰性气体中烧成。主要用作抗氧化的复合材料，应用于宇宙飞船和发动机结构材料等。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条