1) current probe
电流探头
1.
The results of low frequency interference current probe made from ferrite and from Fe based and Co based amorphous alloy, were compared and analyzed.
通过对铁基、钴基非晶合金与铁氧体软磁材料的性能和实际实验结果的分析、比较 ,由于非晶合金自身良好的磁性能 ,将其用于电磁兼容性试验设备中作为低频干扰电流探头的磁芯材料 ,实验证明选用铁基、钴基非晶合金 ,可使电流探头的检测灵敏度、精确度大大提高 ,从而为扩大非晶合金这一功能性材料的应用范围提供了实验依
2.
The principle for calibrating the current probe is introduced in this paper.
介绍了电流探头传输阻抗的校准原理,并对测量不确定度进行了详细的分析评定。
3.
A new approach using two current probes to measure SMPS conducted noise is introduced.
对传统测量开关电源传导干扰方法的优缺点进行了比较,并在此基础上提出了一种基于双电流探头的新测量方法,它可在不中断开关电源正常工作的情况下测量共模和差模干扰,并能在开关电源电磁干扰频率范围内获得较精确的干扰模型。
2) ac current probe
交流电探头
3) RF current probe
射频电流探头
1.
This paper introduces two methods for measuring the conducted interference caused by switching load using RF current probe and line impedance stabilizing network, and the latter is simulated with matlab.
对使用射频电流探头和线性阻抗稳定网络测量开关负载传导干扰的方法进行了介绍,并用matlab对线性阻抗稳定网络测量方法进行了仿真。
4) magnetic field/current probe
磁场/电流探头
5) Surface Current Probe
表面电流探头
1.
Surface Current Probe Based on Photo-Electric Conversion Technique;
一种基于光电转换技术的表面电流探头
6) injection probe
电流注入探头
1.
The simulated models are compared with the experimental characterization of the injection probe, and the result shows the transmission line model is more identical with actual conditions than the lumped-parameter circuit model.
电流注入探头作为一种高效的大电流注入技术广泛运用于电磁兼容性试验。
补充资料：标准冲击电流波形(见冲击电流发生器)
标准冲击电流波形(见冲击电流发生器)
standard impulse current wave form
blaozhun ehonglld}0n4一u box]ng标准冲击电流波形(standard impulse currentwave form)见冲击电流发生器。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条