1)  dye wastewater
料废水
1.
The treatment of acid chrome blue K dye wastewater by electro-generated strong oxidants,H2O2 and HClO was done.
本文研究了用电化学方法生成的强氧化剂H2O2和HClO处理酸性铬兰K染料废水
2)  dyeing wastewater
染料废水
1.
Novel application of tourmaline in environmental field:Treatment of argazol blue BF-BR dyeing wastewater;
电气石在环境领域的最新应用研究:处理雅格素蓝BF-BR染料废水
2.
Treating acid brilliant red GR dyeing wastewater by using composite coagulants;
复合混凝剂处理模拟酸性大红染料废水的研究
3.
Experimental research on treatment of dyeing wastewater with modified bentonite;
改性膨润土处理染料废水的实验研究
3)  pigment wastewater
颜料废水
1.
Study on pretreatment of quinacridinone pigment wastewater by coagulation technology;
高浓度喹吖啶酮颜料废水混凝预处理实验研究
2.
Photocatalysis degration of pigment wastewater was studied by using the anatase TiO2 as photocatalyst and sunshine as light source in the paper.
主要研究了二氧化钛光催化降解颜料废水各因素对COD去除率的影响。
4)  dye wastewater
染料废水
1.
Treatment of direct scarlet 4BE dye wastewater by the hybrid method of Fe/C microelectrolysis and ultrasound radiation;
超声波/铁-炭微电解耦合处理直接大红4BE染料废水
2.
Study on copper-based catalyst for treatment of acidic black dye wastewater by H_2O_2;
H_2O_2处理酸性黑染料废水铜系催化剂的研究
3.
Experimental studies on ozone oxidative treatment of dye wastewater in a rotating packed bed;
旋转填料床中臭氧化处理染料废水的试验
5)  perfume wastewater
香料废水
1.
The characteristics of perfume wastewater are of complicated ingredients and of containing many high consistency and multi-ingredients organic pollutants.
料废水是一种高浓度、成分复杂、难生物降解的工业废水海绵铁是一种新兴的水处理材料。
2.
In this paper,the technological history,current situation and the main developments of perfume wastewater treatment were summarized,especially on the characteristics of biochemical,physical-chemistry treatment and the combination of different processes.
料废水作为一种有毒有害的高浓度有机化工废水,COD浓度高达几万mg。
3.
Also the result showed that the removal effect of perfume wastewater is not better when chose cationic organic coagulant alone,so we chose chloride iron as coagulant aids to improve the removal efficiency.
对香料废水采用HPAM-混凝进行预处理,试验表明:单独使用HPAM有机絮凝剂处理香料废水效果不好,选用氯化铁作为助凝剂处理效果较好;HPAM-混凝的最佳反应条件:废水pH值为9,HPAM投加量为500mg/L,搅拌强度为100r/min,搅拌时间为10分钟,静置时间为60分钟,COD去除率可达43%左右。
6)  paint wastewater
涂料废水
1.
The Paint Wastewater Treatment by Technology of Physiochemical Process and Two-stage Biological Contact Oxiadation;
物化-两段生物接触氧化串联工艺处理涂料废水
参考词条
补充资料:焦化厂含酚氰废水处理设计(见含酚氰废水处理设计)


焦化厂含酚氰废水处理设计(见含酚氰废水处理设计)
design of phenolic and cyanic waste water treatment for coking plant

J iaohuaehang honfenging feishui ehuli sheji焦化厂含酚氛废水处理设计(design of phe-nolie and eyanie waste water treatment foreoking plant)见含酚氛度水处理设计。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。