1) specific essential work of fracture (w e)
比基本断裂功
2) essential work of fracture
基本断裂功
1.
The fracture behavior of the deeply double edge notched tension specimens were studied by the essential work of fracture method.
采用基本断裂功法对共聚聚丙烯压制双边缺口拉伸试样的断裂行为进行研究,分析了厚度变化对材料多项断裂参数的影响。
2.
The essential work of fracture (EWF) method was employed to determine the fracture toughness of four types of co-polypropylene, while the thermal properties and mechanical properties of the materials were analyzed.
采用基本断裂功方法(EWF)评价了四种不同牌号共聚聚丙烯材料的断裂韧性和塑性功,并结合材料的热性能及力学性能进行了分析。
3.
Fracture work revealed that the specific essential work of fracture (W e) of the b.
基本断裂功方法的研究结果表明 ,共混物的比基本断裂功随粉末橡胶用量增多而降低 ,比非基本断裂功则随之而升高 ,且断裂功的变化主要表现在材料屈服之
3) breaking work
断裂比功
1.
The experimental results showed that the breaking strength decreased logarithmically with the increase of clamp distance at constant drawing rate; and the average breaking strength, elongation at break and breaking work all increased with the increase of drawing rate at the same clamp distance.
在相同夹持距离下 ,随着拉伸速率的提高 ,平均断裂强力提高 ,断裂伸长增大 ,断裂比功也增大。
2.
The results showed the loss rates of stress,initial modulus and breaking work were more than 44%,65% and 51% after hydrothermal aging test respectively;but the corresponding parameters were less than 31%,27% and 36% after thermal aging test respectively.
结果表明,在热湿条件下老化结束后,材料的断裂应力、初始模量和断裂比功的损失率分别大于44%、65%和51%;而在热条件下老化结束后,材料对应指标的损失率分别小于31%、27%和36%。
4) specific work of rupture
比断裂功
5) Tensile Breaking Specific Work
拉伸断裂比功
1.
Preparation of Size Film and Research of Tensile Breaking Specific Work;
浆膜的制备及其拉伸断裂比功指标的研究
6) tectonic fault characters
断裂基本特征
补充资料：断裂功
分子式：
CAS号：
性质：纤维受外力拉伸至最大负荷时断裂时所吸收能量，即外力对纤维所作的功。其单位为N·cm。为表征耐冲击的能力。以拉伸曲线下面所包含的面积表示，可用求积仪或积分器求得。
CAS号：
性质：纤维受外力拉伸至最大负荷时断裂时所吸收能量，即外力对纤维所作的功。其单位为N·cm。为表征耐冲击的能力。以拉伸曲线下面所包含的面积表示，可用求积仪或积分器求得。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条