1) outer wall
外壁
1.
Based on the damage of the outer wall, this paper analyzes the reason and law, and proposes the new concept of freezing design in thick overburden and the new construction method.
根据冻结井外壁被破坏的现象,深入分析和研究其中的规律,提出深厚表土冻结设计及施工方法的新思路和新方法。
2.
8m),after organization meticulously, arrangements reasonable,and mechanization working,october record of the outer wall of freezing zone 158.
中煤第七十一工程处在顾桥煤矿南区进风井井筒冻结段外壁施工过程中,克服井筒断面大(净径Φ8。
3.
The technology to prepare anodizing film on the outer wall of aluminum pipes in the pres-ence of external electric field was explored,and the principle was analyzed.
探讨了一种在外加电场作用下,只在铝管外壁制备阳极氧化膜的工艺,并对其原理进行了分析。
2) Outside wall
外壁
1.
The influences of gradient changes of the inside and outside wall of bridge pier on the critical height were investigated by programming.
根据铁摩辛柯能量法,推导高墩大跨T构桥变截面高墩在墩身自体施工阶段和最大悬臂施工阶段临界墩高的计算公式,并通过编程计算T构桥墩身内外壁坡度变化对桥梁临界墩高的影响。
3) outer shaft lining
外层井壁
1.
In view of the retaining problem of outer shaft lining in deep frozen shaft,the structure of outer shaft lining of prefabricated high strength reinforced concrete arc plank is presented.
针对深厚表土层冻结井筒外层井壁的支护难题,结合其受力特点,提出了采用装配式高强钢筋混凝土弧形板结构,并考虑弧形板外壁与冻结壁的共同作用,推导出在不均匀冻结压力作用下装配式弧形板外壁的位移和内力计算公式。
4) outer shaft wall
外层井壁
1.
Variety rules of concrete strain of outer shaft wall were carried out based on in-situ measurement during freeze sinking of Longgu Mine auxiliary shaft.
通过龙固副井冻结凿井期现场实测,获得了龙固副井外层井壁混凝土应变的变化规律。
5) Hot Wall Epitaxy
热壁外延
1.
The CdTe/CdZnTe/Si thin film (Φ30mm) was grown with Hot Wall Epitaxy (HWE) technique.
用热壁外延法 (HWE)生长直径 30mm的CdTe/CdZnTe/Si薄膜 ,经XRD测试说明它是晶面为 (111)取向的立方闪锌矿结构。
2.
This paper reports the growth of GaAs layer on Si substrate by hot wall epitaxy (HWE).
报道了采用热壁外延 (HWE)技术 ,在Si表面生长GaAs薄膜。
3.
GaAs polycrytalline thin films with good performance were prepared on conducting glass and Si by hot wall epitaxy (HWE) , which were suitable for solar cell .
本文介绍以Si和SnO_2／Glass两种材料为衬底，采用热壁外延的方法得到结构良好的，适合作GaAs太阳电池的GaAs多晶薄膜。
6) tube ektexine
钢管外壁
1.
,especially that the guaranteed cleaning of the tube ektexine in different diameters.
与国内现在使用的外壁抛丸设备相比,该设备具有钢丸循环输送能力大、抛丸量大、钢丸与氧化皮及铁锈的分离效率高、噪音以及粉尘排放浓度低等优点,尤其是设备能保证不同管径钢管外壁的清理效果。
补充资料：罐头外壁涂料
分子式：
CAS号：
性质：为防止罐头生锈和使罐头外表整洁、美观而用于罐头外壁涂饰的涂料。必须具备的一般功能是：涂装施工性和干燥性好；在制罐过程中的摩擦、冲击、剪切、弯曲、扭变等加工变形，涂膜不开裂、不剥落、无伤痕；防锈性能好，涂膜右光泽，美化效果好；在罐头杀菌过中涂膜不泛黄、不起泡、不剥落、不开裂。要有醇酸树脂涂料(价格低廉，但保色性一般不好)；丙烯酸树脂涂料(保色性好)；环氧树脂涂料(涂装性能好)。
CAS号：
性质：为防止罐头生锈和使罐头外表整洁、美观而用于罐头外壁涂饰的涂料。必须具备的一般功能是：涂装施工性和干燥性好；在制罐过程中的摩擦、冲击、剪切、弯曲、扭变等加工变形，涂膜不开裂、不剥落、无伤痕；防锈性能好，涂膜右光泽，美化效果好；在罐头杀菌过中涂膜不泛黄、不起泡、不剥落、不开裂。要有醇酸树脂涂料(价格低廉，但保色性一般不好)；丙烯酸树脂涂料(保色性好)；环氧树脂涂料(涂装性能好)。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条