1) Au-Co alloy
金-钴合金
1.
A sulfite Au-Co alloy plating is developed.
研究了亚硫酸盐电镀金-钴合金工艺,并对镀液和镀层的性能进行测试。
2) An-Co alloy
金钴合金
3) gold-chromium-cobalt alloys
金铬钴合金
4) cobalt-based alloy
钴基合金
1.
Investigation of spectroscopic analysis on cobalt-based alloy;
看谱镜在钴基合金分析中的应用研究
2.
8% in mass fraction) on the microstructure and wear resistance of the cobalt-based alloys were investigated using optical microscope, scanning electron microscope (SEM), X-ray diffraction (XRD), and transmission electron microscopy (TEM).
8%的Y2O3对等离子熔覆钴基合金组织结构和耐磨性能的影响。
3.
The effects of 8% Mo on the microstructure and properties of the cobalt-based alloy coating were investigated using optical microscope,scanning electron microscope(SEM),X-ray diffraction(XRD),transmission electron microscope(TEM),and abrasive wear test.
采用光学显微镜,扫描电镜(SEM),X射线衍射(XRD),透射电镜(TEM)和磨粒磨损试验,研究了8%Mo对等离子堆焊钴基合金组织结构和性能的影响。
5) Co-based alloy
钴基合金
1.
Study of microstructure and wear and corrosion resistance of Co-based alloy laser cladding;
钴基合金激光熔覆组织及其耐磨耐蚀性研究
2.
Wear resistance of laser clad Co-based alloy coating on Ni-based alloy
镍基合金表面激光熔覆钴基合金涂层的耐磨性能
3.
Ni-based and Co-based alloy coatings were made on the Q235 steel substrate by oxy-acetylene flame spraying and fusing.
采用氧乙炔火焰喷熔法在Q235钢表面制备了镍基和钴基合金涂层。
6) cobalt-boron alloy
钴硼合金
1.
Magnetic cobalt-boron alloy deposits were prepared by electroless plating.
钴硼合金在镀态下为非晶态结构 ,经热处理后 ,镀层向晶态转变 ,在 40 0℃时 ,硬度和矫顽力达最大。
补充资料：金锗合金
分子式：
CAS号：
性质：金基添加锗的二元低温钎料合金。AuGel2是共晶合金。密度17.5g/cm3。熔点356℃。钎焊温度360℃。合金性脆，很难加工成材。在200℃温度下退火数分钟后，可明显提高塑性。用作半导体器件的钎焊。
CAS号：
性质：金基添加锗的二元低温钎料合金。AuGel2是共晶合金。密度17.5g/cm3。熔点356℃。钎焊温度360℃。合金性脆，很难加工成材。在200℃温度下退火数分钟后，可明显提高塑性。用作半导体器件的钎焊。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条