1) hydrogen plant
制氢装置
1.
Application of JT-4/JT-1G coker off-gas hydrogenation catalysts in a hydrogen plant;
加氢精制催化剂在焦化干气制氢装置上的应用
2.
Reformer hydrogen containing 15 % hydrocarbons has been used to reduce the low temperature CO conversion catalyst, B203 (Cu-Zn-Cr) and B205 (Cu-Zn-Al), in the hydrogen plant of Jinzhou Petrochemical Company.
锦州石油化工公司用重整氢还原制氢装置的低温变换催化剂的工作表明，用含烃15％左右的重整氢还原B203（铜－锌－铬系）和B205（铜－锌－铝系）混装催化剂是可行的，但必须高度重视重整氢中的烃对低变催化剂（尤其是钢－锌－铬系催化剂）还原工作的不利影响，还原操作必须慎之又慎，否则易造成低变催化剂超温烧结事故。
3.
Since the flue gas outlet temperature of reformer in the 50 000 m~3/h hydrogen plant of SINOPEC Beijing Yanshan Company was much higher than the design temperature,cause analysis was carried out.
对中国石化燕山分公司50 000 m~3/h(标准状态)制氢装置转化炉排烟温度高的问题进行了分析,并有针对性地提出了解决方案和改造措施。
2) Hydrogen manufacturing unit
制氢装置
1.
The process scheme, operating conditions for exhausted CO2 recovery in hydrogen manufacturing unit together with the content and effects of the technical improvement were introduced.
介绍制氢装置回收CO2废气的工艺过程、操作条件及技术改造的内容和效果。
2.
The presulfurization of JT-1G hydrogenation catalyst using solid sulfurizing agent and its applicationin the hydrogen manufacturing unit in Jinzhou Petrochemical Company were introduced.
介绍了化工部西北化工研究院研制的JT-1G加氢催化剂在锦州石化公司制氢装置上采用固体硫化剂预硫化及其使用情况。
3.
It is briefly introduced that the expansion program of hydrogen manufacturing unit in the author\' s workplace.
简要介绍了中国石油化工股份有限公司天津分公司炼油部制氢装置扩能改造项目。
3) Hydrogen production plant
制氢装置
1.
Hydrogen production plant has the important position to the balance of hydrogen supply in the refinery flowsheet.
制氢装置在全厂流程中处于平衡氢气供需的重要位置,通过对事故案例的分析,论述 了制氢装置事故处理的经验。
2.
Presented the deactivation of naphtha steam reforming catalysts Z409/Z405G by poisoning and their regeneration procedure in the second hydrogen production plant of Shengli Refinery,analyzed the deactivation reasons,put forward improving measures,and successfully regenerated the deactivated catalysts.
介绍胜利炼油厂第二制氢装置Z4 0 9/Z4 0 5G轻油蒸汽转化催化剂中毒失活及再生过程。
4) hydrogen production facility
制氢装置
1.
The pipe material used in one 4×104m3/h hydrogen production facility is UNS N08810(Incoloy 800H).
4万m3/h制氢装置的炉管材质为UNSN08810(Incoloy800H),通过对UNSN08810材质的化学成分和可焊性进行分析,制定了合理的焊接工艺。
2.
Leakage resulted from split on the welding connection between the lower collecting tubes and the outer pipelines occurred in the invert furnace of a hydrogen production facility.
某制氢装置转化炉下集合管与外接管焊接接头开裂泄漏 ,在内外部表面检查、壁厚测定、渗透检验、超声检测、金相分析、硬度测定和大量的理化实验、材料机械性能和残余应力测试以及腐蚀产物电子探针实验的基础上 ,进行了开裂原因分析 ,并对外接管材料进行了改进 ,取得了较理想的效果 ,保证了生产的顺利进
5) hydrogen production unit
制氢装置
1.
The paper analyzed the scenario of CO2,the by-product of the hydrogen production unit of Sinopec Guangzhou Company.
文章分析了广州石化炼厂制氢装置副产二氧化碳的情况,比选食品级液体二氧化碳生产工艺技术路线,提出了二氧化碳资源有效回收利用途径。
6) Coal to Hydrogen Plant
煤制氢装置
1.
As the Coal to Hydrogen Plant has the characteristics of corrosive,flammable and explosive,selecting and installing of the measuring instrument must follow the specific principles.
介绍了煤制氢装置中检测仪表的选型与控制系统的设计。
补充资料：焦炉煤气脱H_(2)S制硫酸装置
焦炉煤气脱H_(2)S制硫酸装置
71．焦炉煤气脱H2S制硫酸装置
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条