1) chemical resistance
耐介质性
1.
The influence of amount and feeding method of FBA (fluoro methacrylate), dosage of NMA (N-methyl acrylamide) and amount of emulsifier on chemical resistance of fluoro emulsion coatings film through determination of chemical resistance and contact angle of the film.
通过测试含氟乳胶膜的耐介质性,并运用JC2000A静态接触角测量仪测定乳胶膜的接触角,研究了FBA(甲基丙烯酸含氟酯)用量、FBA加入方式、NMA(N-羟甲基丙烯酰胺)用量、乳化剂用量对含氟乳胶膜耐介质性的影响。
2.
And the effect on the water and chemical resistance with introduction of silicon monomer was also discussed.
研究了接枝温度、引发剂浓度对单体接枝率的影响;亲水单体含量、中和度对接枝共聚物水分散稳定性的影响;考察了功能硅单体(A-1757)的引入对接枝共聚物膜的耐水、耐介质性的影响。
2) medium-resistance
耐介质性能
1.
Heat and medium-resistance performance of HNBR;
氢化丁腈橡胶耐热和耐介质性能
2.
With molar ratio of -NCO to HTBN(namely R value), molar ratio of amino-terminated siloxane to HTBN,molar ratio of chain extender to HTBN,and additive wise of amino-terminated siloxane as four main factors,so the influences of various factors were investigated by L9(34) orthogonal experiments on mechanics performance and medium-resistance of HTBN/PU modified by amino-terminated siloxane.
以n(-NCO)∶n(HTBN)、n(硅油)∶n(HTBN)、n(扩链剂)∶n(HTBN)和硅油加入方式为主要影响因素,采用L9(34)正交实验方法研究了各因素对端氨基硅油改性HTBN型PU的力学性能和耐介质性能的影响。
3) stability against medium soaking
耐介质稳定性
4) resistance to medium ageing
耐介质老化性能
1.
different carbon black and different plasticizer on properties of resistance to medium ageing and injection technology were stated, its reasonable manufacture technology was determined, too.
阐述了不同橡胶、不同炭黑以及不同增塑剂对耐介质老化性能和注压工艺的影响，确定了合理的生产工艺。
5) dielectrics voltage-resistance
介质耐压
1.
The testing of insulation resistance,dielectrics voltage-resistance and contact resistance is essential for the connector to reliably operate.
绝缘电阻、介质耐压和接触电阻检验是保证电连接器正常可靠地工作的最基本的常规检验项目。
补充资料：连续性与非连续性(见间断性与不间断性)
连续性与非连续性(见间断性与不间断性)
continuity and discontinuity
11an父ux泊g四f“山。麻以角g、.连续性与非连续性(c。nt，n琳t:nuity一)_见间断性与不间断性。and diseo红ti-
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条