1) Al-Mg base alloy
Al-Mg基合金
2) Mg-Al based alloys
Mg-Al基合金
1.
Effect of alloying on the heat resistance of Mg-Al based alloys;
合金化对Mg-Al基合金耐热性的影响
3) Al-Mg-Si based alloy
Al-Mg-Si基合金
1.
The forming limit of Al-Mg-Si based alloy sheet was tested and the forming limit diagram(FLD) was determined by using FLD test and automated strain analysis and measurement system(ASAME).
采用成形极限图(FLD)试验,运用网格应变自动测试分析系统ASAME,对Al-Mg-Si基合金车身板的成形极限进行了检测,同时,将FLD应用于有限元分析作为成形时出现破裂缺陷的判据,并分析车门外板在冲压成形过程中破裂危险部位主应变在FLD上分布。
2.
Based on nonlinear elastic-plastic finite element theory,this paper has investigated the forming process of a new type Al-Mg-Si based alloy auto door panel by means of numerical simulation.
采用非线性弹塑性有限元法对Al-Mg-Si基合金车门外板冲压成形过程进行了数值模拟,分析了车门在成形过程中的应力、应变、厚度分布以及成形安全裕度的部位和规律,为Al-Mg-Si基合金车身板冲压成形工艺设计及模具设计提供了科学依据。
3.
Al-Mg-Si based alloy auto body sheet will be used widely in the future, but, in the recent, one of the difficulty in practice is its poor formability.
Al-Mg-Si基合金车身板材具有广阔的应用前景,其应用的难点之一是成形性能较差。
4) Al-Mg-Si-Cu based alloy
Al-Mg-Si-Cu基合金
1.
Effect of microelement Sr on corrosion properties of Al-Mg-Si-Cu based alloy auto sheets;
微量元素Sr对Al-Mg-Si-Cu基合金车身板腐蚀性能的影响
2.
Effect of heat treatment between cold rolling on rolling textures of Al-Mg-Si-Cu based alloy sheets
冷轧间热处理对Al-Mg-Si-Cu基合金板材轧制织构的影响
5) Mg-Al-Zn based magnesium alloys
Mg-Al-Zn 基镁合金
6) Al-Mg alloy
Al-Mg合金
1.
Effects of rare-earth element Er on microstructure and mechanical properties of an Al-Mg alloy;
Er对Al-Mg合金显微组织和力学性能的影响
2.
Preparation of Al-Mg Alloy by Powder Metallurgy Forming
Al-Mg合金粉末冶金成形性研究
3.
The Portevin-Le Chatelier effect in Al-Mg alloy investigated by infrared pyrometry
红外测温法研究Al-Mg合金中的Portevin-Le Chatelier效应
补充资料：Ti_(3)Al基合金(金属间化合物)涡轮导风板
Ti_(3)Al基合金(金属间化合物)涡轮导风板
TiaA，基合金(金属间化合物)涡、、风*。利;:，
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条