1) gold content
金含量
1.
The gold content of 91 samples of mantle-derived xenoliths and their host basalts from eastern China were analyzed, and some significant phenomena were discovered.
笔者等分析了中国东部 91件地幔岩包体及其寄主玄武岩中的金含量并有重要发现。
2.
The analyses show that the gold contents of lamprophyres is not higher than that of common igneous rocks and there exist no obvious differences among various types of lamprophyres in different areas, with the average gold abundanc.
对产在不同地区、具不同岩性、且与不同金属矿化有关的煌斑岩金含量分析表明,煌斑岩原始的金含量一般都不高;Rock等人提出的高金含量是煌斑岩的固有特征及有关煌斑岩与金矿化新成因模式的立论依据尚欠充分。
2) Au content
金含量
1.
The distributive characters of Au content in granitic rocks from Au mineralized district inShenglidaban has been studied with fractal theory,The study indlcates that, during ductile shearactiveity,certain part of Au orebodies formed in this way is usually in large-scale,but Au grade isrelatively low and there is no distinct boundary between the orebody and its country rocks.
用分形理论研究了胜利达圾金矿区花岗质岩石中金含量的分布特征，得出花岗质岩石的金是在韧性剪切活动中被激化的。
3) metal content
金属含量
1.
Effects of degumming methods on metal content in puer tea seed oil
脱胶方法对普洱茶籽油中金属含量的影响
2.
In activity improvement,the active components of spent equi- librium catalyst are impregnated and dried,which can increase catalyst micro-activity by 4-5 in addition to the reduction of heavy metal content and the improvement of stability.
废平衡催化剂活性改善技术对废平衡剂进行活性组分浸渍、干燥等处理后,可以使废平衡催化剂的微反活性提高4～5个单位,重金属含量也有所降低,并且具有很好的活性稳定性。
3.
The result shows that the high metal contents of the residuum andhigh temperature of the gasifier are the main reasons for slagging and block up in the gasifier.
结果表明，渣油中金属含量高及气化炉温度过高是气化炉结渣与堵塞的主要原因。
6) alloy content
合金含量
1.
Influence of alloy content on battery performance was studied.
对锂离子蓄电池中电池壳的合金含量进行了研究,发现电池壳中不同的合金含量对电池性能的影响不同。
补充资料：重金属含量测定
分子式：
CAS号：
性质：评价医用高分子材料溶出液毒性的方法之一，采用比色法先制备含铅1×10-5的标准溶液，取溶出液15ml，置比色管内，加氢氧化钠试液5ml，硫化钠试液5滴，摇匀，与标准溶液1.5ml同样处理后加蒸馏水至同样刻度，比较颜色，不得更深，即重金属含量不超过10-6。
CAS号：
性质：评价医用高分子材料溶出液毒性的方法之一，采用比色法先制备含铅1×10-5的标准溶液，取溶出液15ml，置比色管内，加氢氧化钠试液5ml，硫化钠试液5滴，摇匀，与标准溶液1.5ml同样处理后加蒸馏水至同样刻度，比较颜色，不得更深，即重金属含量不超过10-6。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条