1) injection port of gas
进气点
1.
The experiment results showed that the pressure distribution of extruder should guarantee CO_(2) under the supercritical condition in whole extruding process;The injection port of gas should be set up between molten segment and measurement segment to guarantee the melting effect of the polymer and the blending effect of gas and polymer;The bigger the pressure difference between injected ga.
实验显示,挤出机压力分布应保证CO2在挤出全程都处于超临界条件下;进气点应设在熔融段与计量段之间,以保证聚合物熔化和进气后气体与聚合物的混合;进气压力与熔体压力之差越大,则进气量越大,合理的压力差为5~8 MPa;进气量的大小主要受溶解度影响,可用压力差控制。
2) inlet sampling point
进气抽样点
3) hot spot manifold
热点式进气歧管
4) GRIB(grid in binary)
[气]二进制表示的格点值
5) GRIB(gridded binary)code
[气]二进制格点数据编码
6) Intake
[英]['ɪnteɪk] [美]['ɪn'tek]
进气
1.
Prediction model of intake swirl is established based on the experimental results of steady flow rig, which connects the steady testing with the practical intake process.
燃烧室内的空气运动对燃烧过程有重要影响 ,然而实际发动机的缸内气流运动不便直接测量 本文根据稳流气道试验台的试验结果 ,建立了进气涡流预测模型 ,将稳流试验与实际进气过程有机地联系起来 根据所建立模型的模拟计算结果 ,对试验样机的进气道进行改进 改进后的进气道所产生的进气涡流与油束匹配良好 ,降低了发动机的燃油耗和排气温
2.
A set of noise control devices, characterized by high noise reduction and low pressure losses for intake and exhaust systems of high power medium speed diesel engines, were developed, based upon the analysis of the engines characteristics of noise frequency spectrum as well as the intake and exhaust gas flow resistance limits.
基于对大功率中速柴油机进、排气噪声的频谱特性以及消声系统气流阻力的分析 ,文中介绍了一套消声量大、阻损小的消声装置 ,其进气消声量为 5 6dB(A) ,进气阻力为 1 96Pa;排气消声量为 2 8dB(A) ,排气阻力为 5 88Pa。
3.
The cylinder pressure,instant speed and synchronous signal of 6190 direct natural gas engine were measured,the working among all cylinders was compared and the influence of intake unevenness on engine was analyzed.
通过对6190直列燃气发动机进行缸内压力、瞬时转速及同步信号等的测量,对比各缸做功效果,分析各缸进气不均匀性对发动机造成的影响。
补充资料：进点
1.旧时谓演出部门向尊贵者进呈节目单以供选点。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条