1) azodicarbonamide particle size analysis average particle size rapidly test
偶氮二甲酰胺粒度分析平均粒径快速监测
2) azodicarbonamide
偶氮二甲酰胺
1.
The low temperature series azodicarbonamide was prepared by compound method,and the functional mechanism of compound agents was analyzed.
用复配方法制备低温系列偶氮二甲酰胺,并分析复配剂的作用机理。
2.
A novel nano-composite,biurea(LDA) intercalated montmorillonte, was prepared by the novel intercalation-decomposition process of azodicarbonamide (AC) at the presence of mixed dispersant DMSO/H_2O.
以二甲亚砜/水为复合分散剂,通过偶氮二甲酰胺的插层-分解过程,制备出亚肼基二甲酰胺(俗称联二脲)插层蒙脱土新型复合材料。
3.
The new synthesis process technology for azodicarbonamide is oxidation process for biurea using sodium chlorate as oxidizing agent and a halide as cata.
为了解决传统的通氯法生产发泡剂偶氮二甲酰胺(ADC)存在的反应过程难于控制氯气逸出和大量副产品盐酸所导致污染严重、环保费用高的问题,研究了以氯酸钠为氧化剂、卤化物为催化剂联二脲氧化法制备ADC的合成工艺,探讨了各氧化条件对反应过程及产品质量的影响,并得出合理的生产工艺技术参数:BX3、NaBr、助剂W的含量分别为2。
3) azobisformamide
[,æzəubis'fɔ:məmaid]
偶氮二甲酰胺
1.
The temperature and pressure of heatingdecomposition of azobisformamide were measured by Closed Pressure Vessel Test (CPVT),and the onset temperature (XT 0) is the good correlation between CPVT and Differential Scanning Calorimeter (DSC).
采用密闭压力容器试验测定了偶氮二甲酰胺（发泡剂ＡＣ）及其组成物的热分解温度和分解压力。
2.
In this work,azobisformamide was prepared by electro-oxidation method.
本文报道了电化学氧化法制备偶氮二甲酰胺的研究。
3.
Silicon rubber foam was prepared by chemical blowing method using azobisformamide(AC) as blowing,agent urea as blowing promoter,and benzoyl peroxide(BPO) as cure agent.
以偶氮二甲酰胺(AC)为发泡剂、尿素为发泡助剂、过氧化苯甲酰(BPO)为硫化剂,通过化学发泡方法制备了硅橡胶泡沫材料;使用发泡流变仪研究了发泡剂AC在硅橡胶中的发泡性能,使用SEM、电子万能材料试验机分析了泡沫材料的泡孔结构和拉伸性能。
4) azodicarbamide(AC)
偶氮二甲酰胺(AC)
5) average diameter
平均粒径
1.
The resultsshow that the average diameter of particles does nottake a monotone rise, and that it reaches itsmaximum at P_(max).
结果表明，平均粒径不是随Ｎ＿２气压强增加单调上升，而是在某一压强Ｐ＿（ｍａｘ）下，出现最大值。
2.
Effects of the amount of the distilled water, stirring rate, temperature and the amount of the polyvinyl alcohol and resorcinol on the enthalpies and average diameters of the microcapsules were studied.
考察了加水量、搅拌速度、温度、聚乙烯醇用量以及间苯二酚用量对微胶囊相变潜热和平均粒径的影响。
3.
In order to shorten the fussy experimental process in preparing colloidal solutions of silver nanoparticles by pulsed laser ablation in distilled water,a LmNet PF neural network model is developed to approach the complex nonlinear relationship between technology parameters and the average diameter and its distribution for preparing colloidal solutions of silver nanoparticles respectively.
为有效缩短蒸馏水中脉冲激光烧蚀制备A g纳米粒子胶体工艺中繁琐的实验过程,采用LmN et PF神经网络平台对制备工艺与平均粒径及粒径分布的关系进行建模,并将其运用到平均粒径及其分布的预测中去,讨论了激光能量密度、激光重复率、烧蚀时间和平均粒径及其分布的关系。
6) average particle size
平均粒径
1.
The application of PCA-ANN method to PTA average particle size soft sensor;
PCA-ANN方法在PTA平均粒径软测量中的应用
2.
On-line measurement system of average particle size in gas-solid fluidized bed based on acoustic emission analysis and least squares support vector machine;
基于CCA-LSSVM在线检测流化床平均粒径
3.
005mol/L,the average particle size and z.
加入Na+、Ca2+和Al3+均可增加水性油墨粒子的平均粒径,而Al3+的效果最为显著,当Al3+浓度为0。
补充资料：偶氮二甲酰胺
偶氮二甲酰胺又称发泡剂AC，简称ABFA、ADCA，分子量116．1，淡黄色结晶粉末。相对密度(20℃／4℃)1.63～1．65，熔点180℃。溶于碱、二甲基亚砜、二甲基甲酰胺，微溶于乙二醇，不溶于酸、醇、汽油、苯、吡啶、丙酮，难溶于水。分解温度160～200 ℃，发气量200～300mL／g。分解产物主要是氮气(65％)、一氧化碳(32％)、二氧化碳(3％)。室温贮存稳定，在120℃以上易分解，产生大量气体、在密闭容器中易造成爆炸。不易燃，有自熄性。无毒。
用作发泡剂。贮存于阴凉、通风的库房内．防止一氧化碳聚集引起中毒。
用作发泡剂。贮存于阴凉、通风的库房内．防止一氧化碳聚集引起中毒。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条