1) ear stalk
耳轴座
1.
The paper introduced the welding of ear stalk and connecting plate in 30 tons converter.
介绍了 30t转炉托圈耳轴座与连接板的焊接,选择了合理的焊接方法,采用焊前预热、消氢处理,最后进行整体消除应力等措施,从而保证了焊缝质量,达到了设计要求。
2) axle trunnion bearing
车桥耳轴[枢轴、十字轴、摆动支座]轴承
3) manifold lug
耳座
1.
High stress on the manifold lug weld was the main cause of the failure.
本文对某型发动机在使用中发生的三起加力燃油总管固定耳座焊缝开裂故障进行了深入分析,三起故障有诸多相似之处,属于同类故障。
4) axle trunnion
车桥耳轴[枢轴、十字轴、摆动支座]
5) trunnion
[英]['trʌnjən] [美]['trʌnjən]
耳轴
1.
,welded ladle shell is adopted in design of new ladle,reinforced ribs in the bottom of ladle are adopted,at the same time,the trunnion strength and weld strength are checked too.
针对莱钢特钢厂 5 0 t电炉原钢包严重变形等问题 ,设计新钢包 ,采用焊接式钢包外壳 ,并进行加强 ,同时对耳轴强度进行校核。
2.
The fitting clearance between big tilting gear and trunnion of 25t con verter in No.
采用冷焊技术对济钢第一炼钢厂 2 5 t转炉倾动大齿轮与耳轴间过大的配合间隙进行修复 ,方法是对需粘结表面进行预处理后 ,打入切向键 ,进行高分子聚合物浇注。
3.
Using many process improvement measure,improved process control of trunnion forging,reduced faults that forging not filling full and filding,improved the forging quality,the forging efficiency and the forging die service life.
对耳轴锻造采取了多项工艺改进措施,改进了耳轴锻造的过程控制,减少了锻件未充满和折叠等缺陷,提高了锻件质量、锻造效率和锻模使用寿命。
6) trunnion
[英]['trʌnjən] [美]['trʌnjən]
耳轴，挂耳
补充资料：钧窑双耳联座瓶
钧窑双耳联座瓶 元代瓷器珍品。1972年北京市北城出土。高63.8厘米。花瓣形口沿，长颈，颈安双耳，丰肩，上腹圆鼓，下腹较瘦，下联五孔座。釉色以天蓝为主，间有紫、蓝、褐彩斑。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条