1) Jole heat warm-compaction
直热式温压
3) hot-pressing temperature
热压温度
1.
Effect of hot-pressing temperature and natural curing time on properties of fast-curing cement particle board;
热压温度和养护时间对快速固化水泥刨花板性能的影响
2.
thickness and density of panels, hot-pressing temperature, etc.
采用常规热压法对刨花板板坯进行热压,探讨热压时中心层温度变化规律与板坯含水率、板厚、板材密度及热压温度等的关系,结果表明:在快速升温段、升温速度随板厚的增加而明显减小,随热压温度的提高而加快;在慢速升温段,升温速度随板厚的增大而显著加快,随热压温度的升高而明显加速,升温速度受目标密度和板坯含水率影响很小;板坯内水分蒸发所需时间随板厚、板坯含水率、热压温度、板材密度的增长而增加;板坯内水分蒸发温度随板材密度的增加而升高,随板厚的减少而升高,热压温度和板坯含水率对其几乎没有影响;加入胶粘剂会使快速升温段的升温速度有所加快,而使恒温段的水分蒸发温度有所降低。
3.
The relations between the rising velocity of temperature of mat\'s central-layer and moisture content of mats,density,hot-pressing temperature,thickness were analyzed.
【目的】研究板坯含水率、目标密度、热压温度及板材厚度4个因素对棉秆重组材板坯中心层升温的影响,为制定棉秆重组材的热压工艺提供参考。
4) warm forming
温热冲压
1.
Sheet warm forming process, sheet warm hydroforming process and sheet press forging process are introduced in this paper.
介绍了镁合金薄壁板材的温热冲压成形技术、温热液压成形技术和局部热冲锻成形技术。
5) warm-hot extrusion
温热挤压
1.
A new type of lubricant using in warm-hot extrusion of metal materials has been developed according to the features of friction.
在对温热挤压用润滑剂分析的基础上,研究并获得了一种新型石墨基润滑剂,其主要材料是以石墨为基体、氧化铜和氧化铝为添加剂、聚丙烯酰胺为粘结剂。
6) low temperature and pressure
低温热压
1.
To extract leaching copper and iron with the technique of low temperature and pressure in complex copper concentration mineral,this paper finds out most complications which influence their rate and degree of oxidation.
通过对铜精矿进行低温热压氧化提取铜、铁的萃取工艺研究,探讨了初始酸浓度、浸出温度、浸出时间等工艺参数对铜、铁浸出率的影响。
补充资料：温直
1.态度温和，品性正直。语本《书．皋陶谟》:"扰而毅，直而温。"孔传:"行正直而气温和。"
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条