1) Open circuit of thick coal slime systems
粗煤泥系统开路
2) coal slurry open-circuit
煤泥开路
1.
The paper has discussed applying CWM technique to coal slurry treatment system, which ultra-fine coal coming from float-coal system is used to produce CWM, realizing ultra-coal slurry open-circuit ,diminishing the difficulty of coal slurry treatment ,decreasing the grinding coal cost of CWM, increasing the benefit of coal slurry and the level of technique, improving the compose of coal production.
论述了在煤泥水处理系统中应用水煤浆技术将超细粒浮选精煤制成水煤浆，实现超细粒煤泥开路，减轻了煤泥水处理的负担，降低了制浆工艺中的磨矿成本，提高了煤泥产品的附加值和技术含量，改善了煤炭产品结构。
3) rude gas system
粗煤气系统
1.
The lining of the rude gas system shall withstand the erosion and corrosion by the high-temperature gas flow.
粗煤气系统内衬要承受高温煤气流的冲刷和化学侵蚀。
4) Slurry water system
煤泥水系统
1.
This paper introduces the process flow of vibro-assisted jigging and slurry water of Xinghua Coal Washing Plant,and analyzes the existent problems of slurry water system in detail.
介绍杏花洗煤厂动筛跳汰工艺流程和动筛跳汰煤泥水流程,详细分析了该煤泥水系统存在问题。
5) slurry system
煤泥水系统
1.
Research on coal processing system could be focused on coal slurry system,which generally consists of all steps of coal processing.
选煤厂煤泥水系统从广义上包括了选煤系统的全部工艺过程,因此对选煤系统的研究可以集中在对煤泥水系统研究上。
6) coarse coal slime
粗煤泥
1.
Based on comparison made among various methods for calculation of free settling velocity of coarse coal slime,the formula catering for calculation of free settling velocity of coarse coal slime has been derived.
介绍了干扰床分选机的工作原理,在比较了各种粗煤泥自由沉降速度计算方法的基础上,提出了适用于粗煤泥自由沉降速度的计算公式。
2.
The paper describes the performance of novel water-only cyclone and results from test conducted on single conic section water-only cyclone with larger conic angle and new type of water-only cyclone with newly improved conic section structure for treating coarse coal slime.
介绍了新型水介质旋流器的特点、大锥角单锥段水介质旋流器与改进型锥段结构新型水介质旋流器分选粗煤泥对比试验结果和新型水介质旋流器用于兴无选煤厂粗煤泥分选的工业实践。
3.
The paper describes the process of coarse coal slime separation and the flow direction of coarse coal slime.
着重论述粗煤泥的分选和系统中粗煤泥的流向,减少系统中的循环积聚,给重介质回收和浮选作业减轻负担,取得良好的经济效益。
补充资料：开路
开路
open circuit
ko!}U开路(open eireuit)支路中的电流恒为零、支路两端的电压可为任意值的一种特殊工作状态。例如，断开的导线，处于断开状态的开关，反向工作的理想二极管以及电流为零的电流源等都处于开路状态。 在开路时支路两端的电压称为开路电压。开路电压可以用高内阻(理论上应为无限大)的电压表(如晶体管电压表)来测量。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条