说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 充气
1)  Aeration [英][,eiə'reiʃən]  [美][,eə'reʃən]
充气
1.
Study on the Aeration Performance of LHJ Flotation Column;
LHJ浮选柱充气性能的研究
2.
The circular centrifugal flotation cell has many originalities on the pulp aeration, air bubble mineralization, air pulp flow format in the ring shaped tank of the cell, feed method ect, due to the results of fluidics and turbulence and the action of centrifugal and gravitational force ect.
新型高效圆形离心浮选机充分发挥了湍流射流及离心—重力力场的作用,使其在矿浆充气、气泡矿化、浮选槽内矿浆流动形式、给料方式等方面独具特色。
3.
The“dead zone”of particle located at the bottom of annulus can be eliminated,and the effectiveness of solidgas contact,mass and heat transfer can be improved by introducing an auxiliary(aeration or fluidization)fluid into the annular region through a distributor.
在普通喷动床环形区底部引入“充气”可消除环形区底部颗粒“死区”的影响,并能改善环形区气固间的热、质传递。
2)  inflatable [英][ɪn'fleɪtəbl]  [美][ɪn'fletəbḷ]
充气
1.
Simulation analysis of deployment process of inflatable planar antenna structure;
充气平面天线结构展开过程仿真分析
2.
Simulation Prediction of Deployment Dynamics of Inflatable Solar Array;
充气太阳能帆板展开动力学数值模拟预报
3)  inflation [英][ɪn'fleɪʃn]  [美][ɪn'fleʃən]
充气
1.
Analysis of dynamic simulation and fluid field of parachute in inflation stage;
降落伞主充气阶段的动态仿真及流场分析
2.
In order to analyze the acoustic emission signals in the process of contract between coal and gas,the cycle experiments of successive gas inflation-deflation for shaped coal and raw coal samples were carried out,and the characteristics of acoustic emission signals during the process were analyzed.
为了分析在煤体与瓦斯接触过程中的声发射信号特性,分别对型煤、原煤进行了连续的瓦斯充气-放气循环试验,对试验过程中的声发射信号特性进行了研究。
4)  Charge [英][tʃɑ:dʒ]  [美][tʃɑrdʒ]
充气
1.
Comparative experiments were carried out to study the effect of the adsorption heat on the charge and discharge performances of a hydrogen storage system.
5 MPa下快速充气时,在开始100 s左右,储罐吸附床中心的温升可达42 K;在放气试验中,吸附床中心温度在 10。
5)  airing [英]['eərɪŋ]  [美]['ɛrɪŋ]
充气
6)  aerating [英]['eiəreit]  [美]['eə,ret]
充气
1.
In an aerated spouted bed with a draft tube made of poly-methacrylate with internal diameter 92 mm,the glass beads used as experimental material,under the different aerating velocity,the bed pressure drop and particles down moving rate in the annulus were studied.
 在直径92mm的导向管喷动床内,引入充气,对充气对喷动床环形区内颗粒床层的压降、颗粒循环速率以及环形区内气体分布进行研究。
补充资料:充气
分子式:
CAS号:

性质: 通过向料仓气压壁板通入空气使物料移动的过程。在料仓设置橡胶气压壁板,这些橡胶壁板固定在料仓的内壁,将空气周期性地通入,使壁板膨胀,迫使物料进入流动通道。应控制空气的压力防止充气过多,壁板的尺寸和安装要适应存贮料斗的几何形状。充气型装置用可控气体喷射方法很容易充气,也很容易通过各种充气装置将物料从料斗卸出或向工艺流程供料。充气必须使用干燥而清洁的空气,还应控制粉尘,必要时使用收尘器。

说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条