1) bending die with under double wedges
双下斜楔弯曲模
2) two-way wedge
双向斜楔
1.
The float plate block and slide block are controlled by the two-way wedge and located by the ringer.
该模具的凹模由固定部分和活动部分组成,浮动凹模镶块和滑块部分由双向斜楔控制、套环定位,保证了横向和纵向压料的精度,满足了零件质量要求。
3) double inclined wedges
双斜楔
1.
The structure of the bending die with double inclined wedges for forming the frame part and the design of the main parts of the die were introduced.
分析了固定架零件的工艺特点 ,确定了成形工艺方案 ,并介绍了成形该零件的双斜楔弯曲模的结构及模具主要零件的设计。
4) double wedges
双面斜楔
5) bending die with dual-punch
双凸模弯曲模
1.
Aimed at the difficulties in the bending forming of punching parts, the bending die with dual-punch is designed, the complex shape of this part is once formed by the ordinal action of dual-punch.
针对该冲压件弯曲成形难的问题,设计了双凸模弯曲模,通过双凸模的依次动作可一次成形该零件的复杂形状。
补充资料：斜楔式侧孔冲模
工件套在件6上用件9上的台阶定位，而件9用件18防转并且起到圆周方向定位的作用，当上模下行时，件5先将工件压牢，上模继续下行时，由斜楔4推动件11和装在件11上的件8完成冲孔工作。当上模上升时件11在件4的作用下退回，按下件16，工件由与件16相连的件9顶出．
工件图
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条