说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 磷钒钼黄光度法
1)  phosphorus vanadium molybdenum yellow spectrophotometery
磷钒钼黄光度法
1.
The uncertainty of phosphorus pentoxide analysis in silicate using phosphorus vanadium molybdenum yellow spectrophotometery was assessed acoording to JJF1059-1999.
根据JJF1059-1999对磷钒钼黄光度法测定硅酸盐中五氧化二磷的不确定度作了评定,对影响测定结果的各不确定度来源进行了分析,对测量结果的不确定度进行了评定和表述。
2)  vanadium-molybdenum-yellow photometric method
钒钼黄光度法
3)  phosphomolybdic yellow spectophotometry
磷钼黄光度法
1.
When immersing in the water, the coexist elements such as Mn, Fe, Cu, Co, Ni were separated from the solution in the hydroxide precipitation, then P 2O 5 was determinated in the solution by phosphomolybdic yellow spectophotometry.
试样经NaOH熔融,水浸取后,使Fe、Mn、Cu、Co、Ni等共存元素形成氢氧化物沉淀与磷分离,滤液中的磷用磷钼黄光度法测定。
4)  P-V-Mo yellow colorimetric method
磷钒钼黄比色法
1.
Mo-Sb colorimetric method and P-V-Mo yellow colorimetric method were used to determine the content of total phosphorus in different parts of wetland plants,and the difference in determination results obtained by two methods was compared.
利用钼锑抗比色法和磷钒钼黄比色法测定湿地植物不同器官的全磷含量,比较两种测定方法存在的差异。
5)  phosphorus vanadium molybdate yellow
磷钒钼黄
1.
Phosphorus content in zinc phosphate is determined by phosphorus vanadium molybdate yellow colorimetric method.
采用磷钒钼黄比色法测定磷酸锌中磷含量。
6)  Mo Yellow Spectrophotometry
钼黄分光光度法
1.
Microwave Digestion-ICP-AES in Comparison with Potassium Permanganate and Mo Yellow Spectrophotometry for Determination of Ca and P in Feed;
用微波消解-ICP-AES同时测定饲料中钙、磷的含量,并与高锰酸钾法、钼黄分光光度法进行比较。
补充资料:钒磷铁矿提钒


钒磷铁矿提钒
extraction of vanadium from the bear vanadium phosphosiderite

和94%。fantintiekuang tifan钒磷铁矿提钒(extraetion of vanadium frombear vanadium phosphosiderite)以含钒磷铁矿为原料制取五氧化二钒的帆提取方法。主要包括钠化焙烧和湿法漫出两道作业。直接用作提饥原料的是含饥磷铁。 含钒磷铁是饥磷铁矿电炉生产单质磷和磷肥的副产品。钒磷铁矿分布在美国爱达荷、蒙大拿、怀俄明、犹他等州,含Pz05 24%~32%、V:O。0.267%~0.625%和少量的铬、镍和钥等。美国克尔麦吉(Kerr-MeGee)化学公司所用的含钒磷铁含饥3.26%~5 .2%、磷24.7%~26.6%、铁59.9%一68.5%、铬3.4%一5.7%、镍。.84%~1%。先将含钒磷铁磨至粒度小于。.42mm,配入1.4倍纯碱和。.1倍的食盐在回转窑中于1043~lo63K温度下焙烧,钒便转变成水溶性的钠盐。熔烧块在加热到沸腾的水中浸出,钒、铬、磷均溶入浸出液。浸出浆液经过滤处理。滤液冷却结晶析出磷酸钠晶体,用离心机分离。晶体中如仍含有钒和铬,可用水重溶后再结晶分离,直到获得合格的磷酸钠(NaaPO;)晶体产品。若Na3PO‘结晶母液含磷高于0. 989/L时则要加入CaclZ,使其生成磷酸钙沉淀,然后水解回收钒。随后往母液中加入硝酸铅,沉淀出铬酸铅。此工艺的钒、铬和磷的回收率分别为85%、65%
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条