说明:双击或选中下面任意单词,将显示该词的音标、读音、翻译等;选中中文或多个词,将显示翻译。
您的位置:首页 -> 词典 -> 最佳设计
1)  optimum design
最佳设计
1.
With the analysis of the principle of calculating floating head flange and the calculation chart based on the numerical solution, the possible 'optimum design and most economical design were determined.
通过对浮头法兰计算原理分析并以数值解为基础作出线算图 ,对可能存在最佳设计或最经济设计作出判别 ,作出最佳或最经济设计的程序框图。
2.
This paperstudies optimum design conditioned equations of four-stage raw material gas quenchedcatalytic reactor and describes optimum design conditioned equations of this reactor.
本文对四段原料气冷激式催化反应器的最佳设计条件式进行了探讨,导出了该反应器的最佳设计条件式,为催化反应器的优化设计提供了理论依据。
3.
On the basis of the analysis as above,the consummate osillation condition is given in the first place,and the optimum design to the oscillator is also obtained.
本文对崩越模微波振荡器的振荡性能进行了分析,并在此基础上首次给出这种振荡器完善的振荡条件与最佳设计考虑的问题。
2)  optimal design
最佳设计
1.
Dynamic Simulation and Optimal Design Analysis for Diesel Engine Governing System;
柴油机调速系统动态仿真与最佳设计分析
3)  optimal design
最佳化设计
1.
First of all, the equation of shrunk interface pressure and the condition of diametrical ratio are deduced under the optimal design principle of shrunk double-layers cylinder.
首先推导了双层筒体基于最佳化设计原则的缩套界面压力的计算公式及径比条件。
2.
Based on the equation of shrunk interface pressure and the condition of diametrical ratio under the optimal design principle of shrunk-on cylinder, it is found that the diametrical ratio isn t true of the optimal design principle and the distribution of stress isn t very equality through analyzing and calculating the diametrical ratio and stress to a super high pressure cylinder.
利用缩套圆筒最佳化设计原则所确定的缩套界面压力的计算公式及径比条件,对某超高压缸的径比及应力进行了分析计算,发现其径比不符合最佳化设计原则,应力分布也很不均匀。
4)  optimization of design
设计最佳化
5)  optimal design conditions
最佳设计条件
6)  optimum compounding technique
最佳配方设计
1.
n this paper EPDM microwave vulcanization system consisted mainly of microwave vulcanization behaviors,effect factors,microwave heating equipment and optimum compounding technique atc.
本文主要对乙丙橡胶微波硫化的特性、影响因素、微波加热设备和最佳配方设计等进行专题讨论。
补充资料:1350mm双流板坯连铸机(重庆钢铁设计研究院设计)


1350mm双流板坯连铸机(重庆钢铁设计研究院设计)


叠 135Omm双流板坯连铸机(重庆钢铁设计研究院设计)
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条