1) tertiary recrystallization
三次再结晶
1.
Effect of the cross shear rolling technological parameters on tertiary recrystallization of ultra - thin silicon steel strips;
异步轧制对硅钢极薄带三次再结晶的影响
2.
1mm in gauge by conventional rolling(CR) and cross shear rolling (CSR) separately, then the finished strips were annealed in furnace in different atmospheres for tertiary recrystallization.
采用常规和异步轧制分别将0 3mm厚的成品取向硅钢板冷轧到0 10mm以下,然后在不同气氛的热处理炉中进行三次再结晶高温退火,研究同步、异步轧制条件下,热处理工艺参数(退火温度、保温时间、退火气氛、升温速度)对取向硅钢极薄带的磁性能和三次再结晶行为的影响·结果表明,相同的工艺参数下,真空退火的硅钢极薄带的磁性能优于氢气处理的;退火温度越高,保温时间越长,升温速度越快,磁性能越好,三次再结晶发展得越完善
3.
The results indicate that ｛111｝ 〈112〉 and ｛110｝〈001〉texture which are favorable for tertiary recrystallization are increased and disadvan tageous ｛100｝〈011.
在真空或氢气保护下进行高温退火 ,研究不同工艺制度对三次再结晶薄带磁性能的影响规律。
2) secondary recrystallization
二次再结晶
1.
At the starting temperature of secondary recrystallization, 950℃, a certain Sn still segregates at grain boundaries.
在二次再结晶起始温度950℃,Sn在晶界仍有一定的偏聚量,作者认为,Sn通过在晶界偏聚起到了辅助抑制剂的作用。
2.
The results show that final microstructure of the hot-rolled sheet is coarse-grained structure as a result of the occurrence of secondary recrystallization,but the cold-rolled sheet has only a primary recrystallization.
结果表明,MGH754合金热轧板材的终态组织是发生了二次再结晶的粗晶组织,而冷轧板材只发生了一次再结晶。
3.
The results show that transverse rolling sheet could create comparatively perfect structure due to the occurrence of secondary recrystallization.
结果表明:由于发生了相对完全的二次再结晶,横向轧制板材能得到理想的终态组织。
3) primary recrystallization
一次再结晶
4) second crystallization
二次再结晶现象
5) primary recrystallization texture
一次再结晶织构
6) secondary recrystallization annealing
二次再结晶退火
补充资料：二次再结晶(见再结晶晶粒长大)
二次再结晶(见再结晶晶粒长大)
secondary recrystallization
erCI 201」le」Ing二次再结晶(seeondary reerystallization) 见再结晶晶杠长大。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条