1) TN removal rate
氮去除率
1.
TP removal rates and TN removal rates of them strengthened along with the time during the experiment.
结果表明:5种植物对富营养化水体均有明显的净化作用,在水体中生长5 d总氮去除率均在80%以上,总磷去除率(10 d)也达到70%以上。
2) ammonia nitrogen removal rate
氨氮去除率
1.
And ammonia nitrogen removal rate did not decrease obviously.
采用SBR工艺研究了海水进入城市污水处理系统后,对氨氮去除率和短程硝化的影响。
2.
Corresponding to above results,ammonia nitrogen removal rate and short-cut nitrification efficiency were 93.
03 mg/L和9 mg/L,相应的氨氮去除率和亚硝化率分别为93。
3) removal efficiency of nitrogen and phosphorus
氮磷去除率
4) removal rate of ammonia
铵氮去除率
5) nitrogen removal efficiency
氨氮去除率
1.
Several parameters of temperature,pH and NH4+-N load are also studied to evaluate their effects on nitrogen removal efficiency under different salinity.
采用SBR工艺研究了海水盐度对短程硝化反硝化影响,同时研究了不同海水盐度下,温度、pH、氨氮负荷对氨氮去除率的影响。
2.
The effects of its salinity on the nitrogen removal efficiency and short-circuit nitrification have been focused.
在海水盐度小于21g/L情况下(海水比例小于60%),经过驯化,处理系统仍能保持较高的氨氮去除率(大于80%),出水氨氮浓度能达到二类污染物一级排放标准的要求。
6) total nitrogen removal rate
总氮除去率
补充资料:恒定材料去除率是硬铣的关键
图1:摆动铣削的应用可以产生比较恒定的刀具负载水准。 | |
图2:对于相同的切深,刀具咬合方面的差异可能改变刀具负载和表面粗糙度。 |
刀具路径调整
对较小刀具的编程
刀具咬合
说明:补充资料仅用于学习参考,请勿用于其它任何用途。
参考词条