2) cross section quality
断面质量
1.
The experimental results indicate that the minimum discharge voltage of piercing ascents with the increasing of blank thickness and cross section quality is better when the discharge voltage is higher than the minimum discharge voltage under the same blank thickness.
研究结果表明:冲孔所需最小成形电压随着板料厚度的增加而增加;对于同一厚度的铝板,当电压大于最小冲孔电压时,电压越大,断面质量越好;在3种成形方式中,板坯上下放置弹性传压介质的成形方式毛刺区域最小,断面质量最佳,但所需能量最大。
2.
An analysis was made on the influences of big-clearance blanking to the cross section quality of the parts and to the wear of the dies.
对大间隙冲裁与冲件断面质量、模具磨损的影响进行了分析 ,并提出了提高模具寿命的具体方
3) mass and road section
质量断面
4) blanking fracture surface quality
冲裁断面质量
1.
Experiment investigation on blanking fracture surface quality in high-speed & precision progressive stamping
高速精密级进冲压中的冲裁断面质量实验研究
5) quality of tube cutting
断口质量
1.
This paper expatiates on the fracture mechanism of roll-cutting and reveals the reasonable processing parameters combination that affects the efficiency and quality of tube cutting in Φ76mm×3.
5mm钢管滚切生产过程中影响断口质量和生产效率重要工艺参数的较为合理的匹配关系。
6) Quality Diagnosis
质量诊断
1.
The Quality Diagnosis System in Extended Manufacturing;
扩散制造环境下的质量诊断系统
2.
In view of the complexity and fuzziness of business website,a quality diagnosis method based on the multi-attribute and multi-layer fuzzy comprehensive evaluation model including all the quality factors is proposed.
鉴于商务网站的复杂性和质量评价的模糊性特点,提出了基于多属性多层次模糊综合评价模型的质量诊断方法,通过对国内某著名商务网站进行质量诊断的算例详细说明了诊断的步骤并验证了该方法的有效性,并讨论了质量评价和诊断系统实施和进一步提高评价结果客观性的方法。
补充资料：异形断面钢材(见异形断面型材)
异形断面钢材(见异形断面型材)
special section steel
，一、u以uu、’“飞豆on gQngC01异形断面钢材(speeial Seetion steel)见异形断面型材。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条