1) water-absorbent sphere resin
球状吸水树脂
1.
Preparation of high water-absorbent sphere resin by radiation polymerization in inverse suspension system;
辐射悬浮聚合制备球状吸水树脂
2) superabsorbent polymer
吸水树脂
1.
Effect of Superabsorbent Polymer on Water-disintegrable Properties of PS;
高吸水树脂对崩解型聚苯乙烯性能的影响
2.
Preparation and Characterization of Superabsorbent Polymer by Reverse Phase Suspension Polymerization;
反相悬浮聚合工艺制备吸水树脂及其性能研究
3.
A series of superabsorbent polymers with different monomer composition were prepared by emulsion polymerization.
采用乳液聚合法合成了一系列不同单体组成的高吸水树脂,选取吸水树脂与苯乙烯、表面活性剂组成聚合体系,用过氧化苯甲酰引发进行原位共混聚合,制备遇水崩解型聚苯乙烯,并考察了吸水树脂的种类、吸水倍率对崩解材料崩解性的影响。
3) superabsorbent
吸水树脂
1.
Preparation and Properties of Superabsorbent by Graft Co-polymrization of Acrylic Acid onto Different Celluloses of Crops Stems;
富含纤维素类农作物秆与丙烯酸接枝共聚制备高倍率吸水树脂
2.
Synthesis of semi-IPN superabsorbent from PVA and partly neutralized poly(AA-co-AM);
聚丙烯酸类半互穿聚合物网络吸水树脂的合成
3.
Superabsorbent was prepared by graft co-polymerization using acrylic acid onto corn starch.
实验结果表明采用K2S2O8-Na2S2O3引发体系,通过控制引发剂、交联剂浓度,接枝产物吸去离子水可达920 g/g;采用玉米粉代替玉米淀粉与丙烯酸接枝共聚,产物吸去离子水可达870 g/g;这些实验结果进一步提高了吸水树脂的吸水能力。
4) absorbent resin
吸水树脂
1.
Synthesis of acrylic acid(Na)-chitosan absorbent resin;
丙烯酸(钠)-壳聚糖吸水树脂的合成
2.
Research on polyacrylate absorbent resin with post-crosslinking structure;
后交联型聚丙烯酸系吸水树脂的研究
3.
The absorbent resin for hardened basis material was studied by aqueous solution polymerization which was prepared through graft copolymerization of potato starch with acrylic acid initiated by ammonium persulfate and sodium sulfite.
以过硫酸铵-亚硫酸钠为引发剂,采用溶液聚合法,用马铃薯淀粉接枝丙烯酸制备定型基质专用吸水树脂,考查反应温度、中和度、引发剂、交联剂用量对聚合物吸水率的影响。
5) Water-absorbing resin
吸水树脂
1.
The synthesis and properties of polyacrylatic super water-absorbing resin;
聚丙烯酸型吸水树脂的合成及性能研究
2.
The research on the modification of polyethylene with water-absorbing resin
聚乙烯-吸水树脂共混改性研究
3.
The results showed that the volume expansibility of water swollen rubber increased with the increasing amounts of water-Absorbing resin, but its physical properties decreased.
结果表明,吸水膨胀橡胶的吸水膨胀率随吸水树脂用量增加而增大,拉伸强度和拉断伸长率随吸水树脂用量增加而降低;随炭黑用量增加,物理机械性能提高,但体积膨胀率明显下降;建立的数学模型能较好地拟合炭黑和吸水树脂用量与胶料各项性能之间的关系。
6) water absorbent resin
吸水树脂
1.
The technical conditions for synthesizing water absorbent resin of acrylic acid by the method of solution polymerization was determined, i.
确定了采用水溶液聚合法合成丙烯酸系吸水树脂的工艺条件 :单体 :丙烯酸 ( AA) /丙烯酰胺 ( AAM) (质量比 ) =( 1 。
2.
Selecting acrylic acid、acrylamide and 2 propenoic acid 2 hydroxyethyl ester as the monomers of copolymerization,a water absorbent resin used for condensing protein solution has been synthesized by means of water solution polymerization.
以丙烯酸、丙烯酰胺及丙烯酸羟乙酯等为单体合成了浓缩蛋白质溶液用吸水树脂 ,其最大浓缩倍率可达 4。
补充资料：高吸水树脂
分子式：
CAS号：
性质：见吸水材料
CAS号：
性质：见吸水材料
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条