1) cavity charging
空腔装药
1.
With project reality,the short-hole delay millisecond blasting in-hole and the cavity charging blasting technique in the complex environment was adopted to reduce the demolition vibration value of road rock slope,the slope stability and periphery the building security are ensured,and the blasting effect is completely achieved to meet the project request.
结合项目实际,在复杂环境下的道路边坡施工中采用浅眼孔内微差空腔装药爆破技术以降低爆破震动值,确保边坡稳定和周围建筑物的安全,使爆破效果完全达到工程要求。
2) cavity
空腔
1.
Phenomenon of cavity and its size in rectangular moving-bed;
移动床空腔现象及空腔尺寸
2.
Experimental investigation of cavity flow characteristics at subsonic,transonic and supersonic speeds;
亚、跨、超声速下空腔流场特性实验研究
3.
Research on Cavity Acoustics Modal Test in the Interior of Car;
轿车车内空腔声学模态试验研究
3) cavities
空腔
1.
Cross-sectional transmission electronic microscopy(XTEM)was used to study the growth of cavities after the subsequent annealing at 800℃ for 1 hour.
应用透射电镜观测分析了 80 0℃高温退火引起的空腔的形成形貌 。
4) hollow
空腔
1.
Recent development of the application of X-ray spiral computed tomography imaging technologies in diagnosis of hollow organ diseases;
国内X线螺旋CT影像技术在空腔器官疾病诊断中的应用近况
2.
A method to measure the resonant frequencies of sound in cylindrical and conical hollow is presented.
提出一种测量圆柱和圆锥状空腔声共振频率的方法,由微机和信号处理板配合构成的系统完成频响曲线的测量和运算,实验得到的数据和理论计算值相吻
5) hohlraum
空腔
6) cavity effect
空腔效应
1.
For acetic acid,propionic acid and butyric acid with reducing of the inductive effect and increasing of the cavity effect,the apparent adsorption rated constant(k),the interaction energy between the absorbent and the absorbate and the affinity of the absorbate to the absor.
实验结果表明:乙酸、丙酸和正丁酸,吸附速率常数k随着吸附质浓度的增大而逐渐减小;对乙酸、丙酸和正丁酸,因为诱导效应的减小和空腔效应的增大,表观吸附速率常数k是逐渐减小的;吸附质与吸附剂之间的相互作用能逐渐减小;吸附质对吸附剂的亲和能也逐渐减小。
2.
The article introduced the visible emissivity and opening phenomena ——cavity effect which makes the emissivity and the absorptivity increa.
这种由于辐射在空腔内多次反射和吸收使表面吸收率和表面发射率都增大的现象称之为"空腔效应"。
3.
This characteristics of the cavity is so called cavity effect.
由辐射性能一致的漫射表面组成的腔体,在温度一致的条件下,其辐射行为可以归结到由腔体开口的表现来描写,这就是所谓空腔效应。
参考词条
补充资料:串联式空习装药战斗部
[英文]:series shaped-charge warhead[解释]: 反坦克导弹、反坦克火箭和发射的反坦克破甲弹,一 般都采用空心装药战斗部。这种战斗部装药的端有一个圆锥形空腔,紧贴着药覆盖一个金属药型罩。空习装药 可使爆炸产生的能量聚集在对准目标的方向,同时使融化的药型罩形成一股金属射流向前方射出,把装甲击穿 。空习装药战斗部的破甲厚度通常可达药型罩锥口直径的3~5倍,所以装药的直径越大,存甲厚度越大。一般 的破甲弹只有一个空习装药战斗部。为了对付外持反作用装甲的坦克,把两个空心装药战斗部串联起来,前面一 个较小的装药先起爆,炸毁反作用装甲,然后主装药起爆,空透主装甲。这就是串联式空心装药战斗部。这两个 装药的轴线必须严格在一条直线上,破甲的效果才会更好。目前已有不少新型反坦克导弹和反坦克火箭弹采用 串联式空心装药战斗部,例如俄罗斯的AT-7反坦克导弹和 RPG-27、RPG-29反坦克火箭弹,美国的“陶”-2A反坦克导弹 ,法国和德国联合研制的“霍特”-2T、“米兰”-2T反坦克导弹,瑞典的“比尔”-2反坦克导弹和以色列的ZT-35 反坦克导弹待。
说明:补充资料仅用于学习参考,请勿用于其它任何用途。