1) soft material
软材料
1.
This paper describes a modification of the split Hopkinson pressure bar for the dynamic compressive property testing of soft material.
提出了一种用于软材料动态压缩性能测试的霍普金森压杆改进方案。
2.
A modified split Hopkinson device was developed for testing the dynamic properties of some kinds of soft materials such as rubber, elastomer and polymer foams.
本方案克服了传统SHPB在测试软材料时由于子弹长度限制带来的加载幅度不足及由于阻抗失配导致的应变信号微弱的困难 ;与采用高聚物杆的SHPB改进方案相比 ,本方案的测试结果也更为可靠。
3.
Based on this reasonable design,valid constitutive data for two kinds of soft material at high strain rates have been got on SHPB.
通过对SHPB实验中加载波波形进行控制设计 ,实现软材料试样在加载过程中的应力平衡和常应变率加载 ,从而保证SHPB实验的前提条件。
2) soft materials
软材料
1.
Micro-wear test of soft materials(Ⅱ)——ridge formation and influencing factors
软材料的微磨损测试研究(Ⅱ)——有脊磨痕的形成及其影响因素
2.
Micro-wear test of soft materials(Ⅰ)——Wear scar measurement and wear rate calculation
软材料的微磨损测试研究(Ⅰ)——磨痕测量与磨损率计算
3) soft magnetic material
软磁材料
1.
This paper analyzes and discusses the influence of various process parameters and ingredients on physical and magnetic properties of soft magnetic materials.
本文通过分析制造工艺和成分对软磁材料物理性能的影响,筛选出了一种性能较为优良的软磁材料。
2.
The developing process of nano-crystalline soft magnetic material is reviewed in the beginning of this paper.
本文首先回顾了纳米晶软磁材料的发展过程,介绍了纳米晶软磁材料的组织结构与磁特性,分析了优异磁性能的起源;并介绍了纳米晶软磁合金的应用,最后对纳米晶软磁材料的发展趋势作了展望。
3.
Introduction to the material range of PM soft magnetic materials, the effect of processing parameters on properties, application requirements and some application examples are presented in the article, the emphases are focused on the properties and applications of soft magnetic composites developed in recent years.
本文介绍了粉末冶金软磁材料的种类和工艺参数对其性能的影响、应用技术要求以及一些应用实例。
4) Soft substrate material
软基材料
5) soft denture liner
软衬材料
1.
Influence of silver base inorgain antimicrobial on cytotoxicity and tensile bond strength of soft denture liner;
载银抗菌剂对软衬材料细胞毒性及黏结强度的影响
2.
Clinical evaluation of soft denture liner material on satisfaction of complete denture;
软衬材料对全口义齿满意度影响的临床观察
6) material softening
材料软化
1.
The obvious material softening character of SFRC after compression-shear failure,indicated by the bilinear shear softening curve,can be observed from test data.
通过改变压应力和钢纤维掺量,研究了钢纤维混凝土的压剪破坏,结果表明:钢纤维混凝土压剪破坏后具有明显的材料软化特征,可用双线性剪切软化曲线表示;钢纤维混凝土压剪强度与其压应力和钢纤维掺量有关,但该两者的增强效果并不叠加。
补充资料：丙烯酸酯类义齿软衬材料
分子式：
CAS号：
性质：分甲基丙烯酸酯类和亲水性丙烯酸酯类两大类。前者由粉剂和液剂组成，并可加入芳香酯或乙醇等。缺点是软性保持时间短，易变色、变脆。后者由聚甲基丙烯酸羟乙酯、甲基丙烯酸羟乙酯、交联剂等组成，可用自凝或热凝法成形，吸水后更为柔软。
CAS号：
性质：分甲基丙烯酸酯类和亲水性丙烯酸酯类两大类。前者由粉剂和液剂组成，并可加入芳香酯或乙醇等。缺点是软性保持时间短，易变色、变脆。后者由聚甲基丙烯酸羟乙酯、甲基丙烯酸羟乙酯、交联剂等组成，可用自凝或热凝法成形，吸水后更为柔软。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条