1) spall strength
层裂强度
1.
Temperature dependence of dynamic yield strength and spall strength for LY12 aluminum alloy under shock loading;
冲击加载下LY12铝合金的动态屈服强度和层裂强度与温度的相关性
2.
Influence of pre-stress on spall strength of LY12 aluminum
预应力对LY12铝层裂强度的影响
3.
According to the curve,the spall strength,the thickness of spall scab and the tensile strain rate under different condition were obtained.
根据所得曲线波形计算出相应条件下的层裂强度、层裂片厚度以及各自的应变率,最后得到层裂强度随拉伸应变率变化的关系曲线。
2) spalling strength
层裂强度
1.
A novel experimental technique to determine the spalling strength of concretes;
混凝土层裂强度测量的新方法
2.
The spalling strength of 45# steel is investigated.
本文在利用轻气炮加载技术,确定击靶速度为500m/s左右的非对称碰撞情况下,利用VISAR测试技术,测得样品后表面的的自由面速度历史,并通过在靶前加不同阻抗的铝和有机玻璃(PMMA)来改变材料的加载应变率,其应变率范围在104～105/s情况下,测得45钢的层裂强度受应变率的影响。
3.
The spalling signal were recorded directly by the split Hopkinson pressure bar(SHPB) technique,and the spalling strength of a long concrete rod was determined.
采用波形整形技术、万向头技术和应变直接测量技术测量了混凝土材料的动态应力-应变曲线;通过损伤"冻结"试验及相应的MTS静态试验研究了混凝土材料的损伤演化规律;利用Hopkinson压杆技术直接测得层裂信号,进而可确定混凝土材料的层裂强度。
3) spallation strength
层裂强度
1.
The stress history measured by man-ganin gauge embeded in target/window interface demonstrated that the spallation strength of the tungsten alloy is a monotonic increasing function of square root of tensile str.
由锰铜压阻计测量样品靶后界面应力历史表明,此种钨合金的层裂强度与拉伸应力率的平方根星单调递增关系。
2.
The material s spallation strength is decrease.
采用热装配方法对平面样品施加径向应力,获得不同程度的偏应力,通过轻气炮实验获得了不同预应力下LY12铝合金层裂信号,结果表明:即使在相同撞击速度下,材料的层裂强度差异也发生明显变化。
3.
The experimental results show that the pullback amplitudes of the free surface velocity and the spallation strength of the sa.
采用过盈配合的热装配方法对平面样品施加了径向预应变,一维平面应变气炮实验结果显示初始预应力(变)明显降低了LY12铝层裂强度。
4) Laminier-tear strength
层间撕裂强度
5) fracture strength
断裂强度
1.
Fracture strengths of domestic ceramic orthodontic brackets during mesial-distal archwire tipping;
国产陶瓷托槽在近远中倾斜力下断裂强度的实验研究
2.
Fracture strength of domestic ceramic orthodontic brackets during archwire torsion;
国产陶瓷托槽在转矩力作用下断裂强度的研究
3.
Force controlling method for measuring fracture strength and toughness of diamond film;
测定金刚石膜断裂强度及断裂韧性的力控制法研究
6) breaking tenacity
断裂强度
1.
Influence of polypropylene tow fiber on hardness, weight, circumference, sucking resistant index of filter stick and finished filter stick rate was discussed under different breaking tenacity and breaking elongation.
本文介绍了烟用聚丙烯丝束在不同断裂强度、断裂伸长的情况下 ,丝束对其成棒后滤棒之硬度、重量、圆周、吸阻指标及成棒率的影
补充资料：脆裂强度
分子式：
CAS号：
性质：物体在脆性断裂时的拉伸强度。
CAS号：
性质：物体在脆性断裂时的拉伸强度。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条