1) fore-oxidized ore
预氧化矿
1.
Through comparing different effects of Panzhihua ilmenite and fore-oxidized ore on the grade of thick synthetic rutile and the pulverization rate of product after acid leaching,it is described that fore-oxidation has functions of improving the grade of thick synthetic rutile and reducing the pulverization rate of products.
论述了预氧化机理、酸浸反应机理和细化机理,并通过攀枝花钛铁矿与预氧化矿在1000t/a生产装备上的对比试验,考察了两种矿对酸浸后粗金红石品位及产品细料率的影响,阐明了预氧化有提高粗金红石品位、降低产品细料率的作用。
2) Air pre-oxidation of ore stratum
空气预氧化矿层
3) pre-mineralization unit
预矿化器
4) mineralization forecast
矿化预测
1.
Compared processed EM38 data with the abnormal characteristics of Cu element,the mineralization forecast is made.
将去噪后的数据与地球化学铜元素的异常特征和已知的铜矿化区域进行分析与对比,推测出该地区的铜矿化预测区。
5) oxidized copper ore
氧化铜矿
1.
In this paper,a series of leaching tests on highly oxidized copper ore in Yunnan Province are conducted in the laboratory,such as leaching tests on different grinding meshes,leaching time,the ratio of liquid to solid,the consumption of sulphuric acid,etc.
本文主要介绍了云南某高氧化率的氧化铜矿使用硫酸进行浸出试验情况。
2.
The characteristic of the refractory oxidized copper ore is the high oxidation ratio,the high combination ratio,the target is bad by flotation.
某难选氧化铜矿石氧化率和结合率高,用浮选方法处理,选别指标不理想。
3.
The characteristic of the refractory oxidized copper ore is the high oxidation ratio,the high combination ratio,the low grade of raw ore,it can't reach ideal target by flotation.
某难选氧化铜矿石氧化率和结合率高,原矿品位低,选别指标不理想。
6) lead oxide ore
氧化铅矿
1.
The recent advances of flotation for lead oxide ores have been reviewed from the flotation technological flowsheets and flotation reagents in this paper.
重点从浮选工艺流程和浮选药剂两方面介绍了国内外氧化铅矿浮选研究和应用的进展情况,并指出氧化铅浮选存在的问题和今后发展的主要方向。
2.
Aiming at a low-grade complex lead oxide ore with deep oxidation and high content of silicon in Yunnan province,ethyl thio carbamate and new collector LW13 was used in flotation of galena and lead oxide ore respectively.
针对某品位低、深度氧化且含硅较高的复杂氧化铅矿,采用乙硫氮和新型药剂LW 13为捕收剂,分别浮选方铅矿和氧化铅矿物,在原矿铅品位为8。
补充资料：磁性氧化铁环氧预涂底漆
分子式：
CAS号：
性质：是以环氧酯为主要成膜物，以磁性氧化铁为防锈颜料制成的车间预涂底漆。漆膜呈银棕色、平整无光。采用喷涂、辊涂；无空气高压喷涂施工。主要用于造船工业、铁路机车工业及钢结构件抛丸自动除锈喷涂底漆流水作业线。可与醇酸底漆、环氧底漆、硝基底膝及氯化氯丁胶底漆配套使用。
CAS号：
性质：是以环氧酯为主要成膜物，以磁性氧化铁为防锈颜料制成的车间预涂底漆。漆膜呈银棕色、平整无光。采用喷涂、辊涂；无空气高压喷涂施工。主要用于造船工业、铁路机车工业及钢结构件抛丸自动除锈喷涂底漆流水作业线。可与醇酸底漆、环氧底漆、硝基底膝及氯化氯丁胶底漆配套使用。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条