1) surface acid strength
表面酸强度
1.
Based on determination of the kinetic model equation of TPD,a new simulation method used to characterize the surface acid strength was developed by using one group of TPD experimental data.
对含不同脱附峰数的TPD数据的脱附动力学模拟结果表明,脱附活化能变化的顺序与脱附峰温度的变化顺序相同,使对催化剂表面酸强度的脱附峰温度的定性比较发展为数学层次的脱附活化能表征。
2) surface acidic strength
表面酸性强度
3) surface strength
表面强度
1.
On the methods to increase the surface strength of finished paper;
提高成纸表面强度途径的探讨
2.
Effects of wetting rate on soil surface strength and aggregate stability;
湿润速度对土壤表面强度和土壤团聚体结构的影响
3.
The effect of fiber composition and beating process on surface strength of off-set printing paper;
纤维配比和打浆工艺对双胶纸表面强度的影响
4) surface acidity
表面酸度
1.
The results showed that the pore structure and surface acidity of carrier were affected by treating time,space velocity and calcination temperature evidentially.
结果表明处理时间、空速及焙烧温度对催化剂载体的孔结构和表面酸度均有显著影响;与在空气中焙烧相比,在有水蒸气存在的条件下焙烧,载体的相对酸度由1。
2.
The results showed that the F-existing on the the surface of catalyst changed the surface acidity,increased the amount of absorbed organism.
结果表明:氢氟酸处理的纳米TiO2,由于F-存在于纳米TiO2表面,改变了表面酸度,增加了有机物的吸附量,使得同等实验条件下采油污水COD去除率得到了提高,其光催化剂和H2O2的最佳使用量分别为10 g/L和80 mg/L,体系的pH值范围为8~10。
6) surface bonding strength
表面结合强度
1.
This paper analysed the influence of specimen thickness on test results of surface bonding strength of thin MDF.
分析比较薄型中密度纤维板试件在检测时组合厚度的改变对其表面结合强度测试结果的影响。
2.
The influence of changing the milled groove depth on testing results of the surface bonding strengthof MDF was analysed through experiment.
通过试验分析比较铣槽深度的改变对中密度纤维板表面结合强度测试结果的影响。
补充资料：表光合强度(见光合强度)
表光合强度(见光合强度)
forecast of sowing or transplanting time
b iaoguanghe qiangdu表光合强度见光合强度
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条