1) Slurry Polymerizer
淤浆聚合反应器
2) Slurry reactor
淤浆反应器
1.
Sulfur dioxide oxidation catalyzed by activated carbon in a slurry reactor (at room temperature and atmospheric pressure) was studied .
研究了常温常压下淤浆反应器中SO_2催化氧化反应,通过改变反应物的进口浓度和测定小颗粒床层平均氧化反应速率(此时传质阻力最小),间接验证了假定的反应机理:氧在活性炭活性位上的吸附为速率控制步骤,本征反应速率相对于颗粒表面的溶氧浓度为一级,而与此浓度范围内的SO_2浓度无关,通过改变催化剂的用量、粒径及反应温度,测定了各模型参数。
3) Reaction slurry
反应淤浆
4) slurry polymerization
淤浆聚合
1.
The isotactic polypropylene prepared under the supercritical conditions was compared with that obtained by a conventional slurry polymerization with respect to the isothermal crystallization kinetics by Perkin Elmer differential scanning calorimetry(DSC) and Nikon E600 optical polarimeter(OP) with on-line hot stage,respectively.
采用差示扫描量热法及带热台在线偏光显微镜直接观察法,研究了超临界聚合与常规淤浆聚合这两种不同聚合工艺所制备等规聚丙烯的等温结晶行为。
2.
The Cp 2ZrCl 2/MAO catalyst was evaluated with ethylene slurry polymerization by pilot test.
研究了负载型茂金属催化剂二氯二茂锆 (Cp2 ZrCl2 ) /甲基铝氧烷 (MAO)的模试负载工艺 ,讨论了二氧化硅活化、负载温度、负载时间、MAO和Cp2 ZrCl2 用量对其聚合活性的影响 ,并对该催化剂进行了乙烯淤浆聚合中试评价 ,同时考察了MAO残液的循环利用情况。
3.
Behavior of propylene slurry polymerization was investigated at 15 ℃ , 0.
考察了N催化剂与助催化剂及外给电子体的预络合反应对丙烯淤浆聚合动力学行为的影响。
5) three-phase bubble column slurry reactor
三相鼓泡淤浆床反应器
6) threephase slurry reactor
三相淤浆床反应器
1.
Taking two systems of airwatercatalyst and airparaffin oilcatalyst with high solid concentration, the hydrodynamics of the threephase slurry reactor including average gas holdup, bed pressuredrop, and critical gas velocity for complete suspension of solid particles, has been studied.
在空气 -水 -甲醇合成催化剂、空气 -液体石蜡油 -甲醇合成催化剂两种系统中 ,研究了高固含率下 ,三相淤浆床反应器的平均气含率、床层压降、临界气速等流体力学性质 ;考察了各种因素的影响 ,并得到了气含率的经验关联式。
补充资料：淤渟
1.水淤积不流。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条