1) Cu-Fe-P Alloy
Cu-Fe-P合金
1.
Microstructure and Properties of Aging Cu-Fe-P Alloy;
时效态Cu-Fe-P合金组织和性能的研究
2.
Numerical Simulation on the Effects of Fe Particles Density on Residual Stress of Cu-Fe-P Alloy;
FE颗粒密度对CU-FE-P合金残余应力影响的数值模拟
3.
Study on heat resistance of Cu-Fe-P alloy used for IC lead frame;
IC引线框架用Cu-Fe-P合金耐热性能的研究
2) Cu-0.1wt%Fe-0.03wt%P alloy
Cu-0.1wt%Fe-0.03wt%P合金
1.
Effects of thermomechanical treatment on microstructure and properties of Cu-0.1wt%Fe-0.03wt%P alloy;
形变热处理对Cu-0.1wt%Fe-0.03wt%P合金组织和性能的影响
3) Fe-P-C-Cu-Mo-Si amorphous alloy
Fe-P-C-Cu-Mo-Si非晶合金
4) Cu-Fe alloy
Cu-Fe合金
1.
Solution and aging treatment of Cu-Fe alloys imposed by a high magnetic field
Cu-Fe合金的强磁场固溶时效行为
2.
Fine powders of the Cu-Fe alloy were manufactured by using the high-pressure gas atomization technique.
采用高压气体雾化技术制备了Cu-Fe合金粉末,并对粉末的组织进行了观察分析。
3.
The microstructure and properties of Cu-6%Fe, Cu-12%Fe and Cu-6%Fe-RE (mass fraction) alloys were investigated at various drawing ratios and the effect of Fe content, rare-earth elements and heat treatments on the microstructure and properties of the Cu-Fe alloy was discussed.
本文采用强烈冷拉拔结合中间热处理工艺制备了纤维相复合Cu-6%Fe、Cu-12%Fe和Cu-6%Fe-RE合金线材,研究了合金在不同变形程度下的组织及性能,探讨了不同Fe含量、稀土元素及不同热处理工艺对Cu-Fe合金组织与性能的影响。
6) Fe-P alloy
Fe-P合金
1.
Study of Fe-P alloy brush plating using soluble anode;
可溶性阳极快速刷镀Fe-P合金的研究
2.
Fe-P alloy was prepared by electroless deposition and the corrosion behavior of electroless Fe-P deposits in 1 mol/L NaOH media was investigated by electrochemical method.
用化学镀的方法制备Fe-P合金,分析化学镀层在1mol/LNaOH介质中的腐蚀行为。
3.
The plating conditions of chemical plating of Fe-P alloy were discussed.
研究了化学镀Fe-P合金中镀液组分和工艺变化对化学沉积速率的影响。
补充资料：A1-Cu-Co合金中十次对称准晶单晶体及其衍射图
A1-Cu-Co合金中十次对称准晶单晶体及其衍射图
‘ Al Cu—Co合金中十次对称准晶堕晶体e1)及其衍射圈(z) 中国科学盹垒禹研览听供稿
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条