1) general heat pipe
普通热管
2) common high temperature heat pipe
普通高温热管
1.
One of them is the small high temperature heat pipe called as high temperature heat pipe fin, the other is the long high temperature heat pipe called as the common high temperature heat pipe here.
对两个直径是 2 5cm ,长度分别是 6cm和 10 0cm的两高温热管进行实验研究 (前者小热管被称为高温热管翅 ,后者大热管为普通高温热管 ) ,给出起动与运行过程的温度分布曲线。
3) delivery pipe with conventionnal insulation
普通绝热输液管
4) conventional heating
普通加热
1.
Nanosized zeolite T with the mean size range of 80～150 nm was synthesized by conventional heating or microwave heating at 85 ℃ with the addition of 10% template.
在85℃和添加质量分数为10%模板剂的条件下,采用普通加热或微波加热方法合成了平均粒径在80~150 nm范围的T型分子筛。
2.
Compared with the conventional heating method, not only was crystallization time reduced over 80%, but also the crystallinity and surface area of crystals were improved.
T型分子筛的合成研究较少[5￣11],制备过程均采用普通加热(ConventionalH eating,CH)法。
5) general tubesheet
普通管板
1.
For approximate calculation,the tubesheet was trasformed to general tubesheet by using this method.
通过对一台蒸发器中环形管板的设计 ,运用GB15 1— 1999《管壳式换热器》中的方法将其转化为普通管板进行近似计算 ,并分析、验证环形管板设计的可靠性、合理。
6) Plain detonator
普通雷管
补充资料：4063m~(3)高炉热风炉分离式热管换热器
4063m~(3)高炉热风炉分离式热管换热器
1270
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条