1) Prestressed work-clip
预应力工作夹片
2) working-clip
工作夹片
1.
The hardness,microstructure and tension property of LM15 type working-clip were tested and analyzed in this paper.
对LM 1 5型工作夹片的硬度、金相组织和拉伸性能进行了检测分析。
3) prestressing tendon anchorages
预应力锚夹具
4) prestressed sandwich slab
预应力夹层板
1.
The lower layer of the superposed floor is precast-prestressed sandwich slab, and the upper layer is cast-in-situ concrete.
本文所研究的装配整体式预应力夹层板楼盖是适用于大开间、大柱网高度在50m以下的各种建筑的楼盖结构体系。
5) precast and prestressed concrete lining
预应力管片
1.
As for a new structure,it is necessary to explore the stiffness of precast and prestressed concrete lining for shield tunnels.
盾构隧道普通混凝土管片接头的抗弯刚度主要是通过现场试验确定,目前尚无现成的公式或者图表可遵循,对于预应力管片这一新型的结构型式则更有必要对其接头的正负转角刚度,为此进行了弯曲的预应力管片接头试验。
6) working stress
工作应力
1.
In the article, the numerical simulation software ANSYS is used to analyze the working stress distribution in butt joint and the effect of the geometric parameter on the stress concentration efficiency.
通过数值模拟软件 ANSYS分析对接接头的工作应力分布 ,找出了对接接头的几何参数对应力集中系数的影响 。
2.
The crankshaft gears of diesel engine,which are interference assembled,suffer working stress from the root as well as the original interference assembly stress.
过盈装配的柴油机曲轴齿轮,其齿根部除承受工作应力外,还要叠加原始过盈装配应力。
3.
Based on experimental research, a finite element analysis to inspect constant working stresses of structures by grooving method is presented.
通过实验和有限元分析,研究了开槽法测试结构不变工作应力的可行性,根据有限元计算结果分析了开槽深度和槽间距与应力释放率和应力集中系数之间的关系,提出了采用开槽法测试结构工作应力时应选择的合理开槽深度和槽间距。
补充资料：夹片
1.清代官吏向皇帝上疏或向上司禀事﹐遇有不便写于一起的情节﹐或另有所陈﹐则用另帖书写﹐夹在奏折或手本的第一幅内﹐叫"夹片"。
说明：补充资料仅用于学习参考，请勿用于其它任何用途。
参考词条